Got some back seat covers for my car.

Ive got the back bit of the back seat on, but the problem im facing here is that I have NFI how do get the back seat covers on (well the bit were you sit your bum on).

Mines a sedan and i dont think you can just pull the rear seat off like you can in the hatch and wagon (the manual doesnt show that its possible - and i tried and i couldnt pull it off yesterday).

Does anyone know how i can place the rear seat covers on? I can kinda slide them under, but it doesnt hold properly, i want to be able to tie the ends together so they dont slide out of place no matter how much you wiggle your bum on them.

if they are toyota seat covers take it to a service dealership and get them to put it on. my front seats had to be removed for them to put the seat covers on properly.

all the best,
lauschie

just came back from the seat cover store.

Fitting the back seats are extremely easy.

For the sedan its held together by two clips.
The clips are actually in the same place as shown the diagram in the user manual for the hatch and wagon (except that the fact that the sedan doesnt have the two holders for you to pull up on).

However if you get your hand underneath and give it a quick yank it should come off without any hassles.

Putting the seat back on afterwards its easy, just lay it in place and hit it down, it should go "click" and your done.

Hopes this helps other corolla sedan owners.

(Btw i bought my seat covers from Ryan Seat Covers on the corner of Canterbury Rd and Fore St Canterbury 2193 - got from and back for $75 )

have you got pics ???

like of how it looks now .. after install ???

looks better, its just a standard black & grey mesh type fabric (similar to the ones you find at KMart/AutoBarn/etc).

The fit quite well and dont slide around when you park your bum on it. (Which is the main reason i picked these over throwovers)