matt_glad

Hey Daniboy did you manage to find out if it works with our speedo gears with out any modification? or do our spedos run off the abs ? slightly confused lol.. Regards dave Edit: Has any one tried one of these guys yet , im very tempted but every single forum site is saying the build quality is poor and they need to be rebuilt, i wonder if the lsd would be strong enough with our engines in n/a condition. Has any one done a obx lsd rebuild by any chance ? Regards My one looked good quality lots of Honda people run them no need to rebuild after 40,000 km! Still working good Did you DIY it with the washers, or did you get someone to do it for you? Can you make up another one if sent over to you? Best to get the factory one out theres a guide on newcelica for doing the lsd somewhere Then check if it needs the speedo ring if your mechanic says yes it does Then take obx and factory one to an engineer with a spark eroder cost me $100 bucks to get done Then the factory ring fits on with a a thin slice of metal to keep it in place

Hey Daniboy did you manage to find out if it works with our speedo gears with out any modification? or do our spedos run off the abs ? slightly confused lol.. Regards dave Edit: Has any one tried one of these guys yet , im very tempted but every single forum site is saying the build quality is poor and they need to be rebuilt, i wonder if the lsd would be strong enough with our engines in n/a condition. Has any one done a obx lsd rebuild by any chance ? Regards My one looked good quality lots of Honda people run them no need to rebuild after 40,000 km! Still working good

Curiosity Matt, does the JDM Runx have a speed signal running from the gearbox? Was diagnosing a problem on a zze122 the other day and was looking at the speed sensors between the Celica, zze122 and zze123; and my zze123 didn't have the speedo sensor in the same place. So just curious if yours is the same or not? Just wondering if the vehicle speed comes from the ABS ECU on the Sportivo. The problem on the zze122 ended up being a broken cluster BTW. Yea I was not sure my guy who fitted the LSD said we needed it, it was not hard to gest lsd spark eroded and fit the speedo wheel which was on the factory lsd. I think you may not even need it

Uprated Tein springs to 300lb at the front

Yup it is, been working great too.

140kw is possible I got 130kw with .. Injen intake, 2.5 inch exhaust from headers, Ported headers, Camcon to adjust fuel and vvti, Hondata manifold gasket, coolant bypass, lightweight flywheel, lightweight wheels. (Last two mods may not make kw) So trow in some cams with the power fc and you would be close

I tried all the plugs on my gearbox and none stopped speedo if anyone know how to stop mileage I would be interested!

I love my fizanza it the lightest around and only $290 usd from ebay :) After fitting car was quicker and loves to rev faster, did not even seem any harder to drive like people say. One of the best mods (With LSD)

I just ordered one of these http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=230420778777&ssPageName=STRK:MEWNX:IT

One could have had a dirty filter my CAI gets dirty quicker due to placement Also oil type and plugs do make a difference

Yep did not last long with doing 9'000 rpm! fuck that is dodgy as hell... Dont know where the other two fins went either! Must be in the engine somewhere :P The whole thing is ready so snap in half!

Yep did not last long with doing 9'000 rpm!

Replaced my water pump with an ebay ITM pump 10 months later it broke almost cooking my engine. Dont go cheap on any part go OEM!

Yep possible if you port header you should gain a little back all over rev range I put in a high flow cat and seemed to notice low down power came back a little.