AdBlock Warning

Parts of this website do not function properly with AdBlock enabled on your device. To get the best user experience on our website, please disable Adblock for this website (domain) on your browser.


Jim.

Clutch pressure plate bolts torque setting required.

Recommended Posts

Jim.    3

I am removing the manual transmission in my 1993 Camry. I'll be removing the clutch to replace the rear main oil seal.

Can someone please advise the torque wrench settings to tighten the clutch pressure plate retaining bolts please?

My old digital service manual is no longer readable as the operating system it runs in (Win 7) is no longer booting. I normally use Linux Mint for most computing operations.

Jim.

 

Solved.

Edited by Jim.

Share this post


Link to post
Share on other sites
 
trentmeyer23    467

It's around 20Nm from memory. I will confirm when I return home.

Share this post


Link to post
Share on other sites
Jim.    3

Never mind looking further Trent. I was able to open the operating system that I have my Mitchell On Demand service manual installed on.

The figure in my Manual is 14ft/p or 19 nm.

Your memory is good! Thanks anyway.

 

Jim.

Share this post


Link to post
Share on other sites
trentmeyer23    467

You are correct with 19Nm.

Share this post


Link to post
Share on other sites
Jim.    3

Thanks again for checking Trent.

Job done.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Recently Browsing   0 members

    No registered users viewing this page.