[SYD] blacktown drive-in cinema outing april 17 or 18
-
Latest Postings
-
16
CH-R sudden engine failure
I fought with Toyota for the last 6 months on this issue. I attempted to reject my vehicle due to safety and Toyota began to investigate my request. During this time they offered me a new engine. I asked if a new engine would affect my rejection claim and they said no. After this they rejected my claim and I supposedly have no further argument as essentially the new engine was a satisfactory response to a major failure under consumer rights. After months Toyota still won't tell me what damage there was that required my engine to be replaced. Other than confirming carbon build up on the manifold months prior to engine replacement. They will not give me any information. Everyone I speak to tells me they cannot comment. I never wanted the repair because the problem is so common I don't feel the repair was enough to prevent a reoccurrence. I even asked for confirmation that a repair would be enough to prevent further occurrence and that the vehicle was safe and would no longer lose power on acceleration. They responded to this with a letter stating Toyota could not provide the information or guarantees I had requested. -
1
Finally found all Tarago's 6 speakers - 2 in roof lining
I had a look on my 2019 Tarago but couldn't find it in the roof lining. They must have removed it on the 2019 model -
3
P0303, rough idle, check VSC message.
Haha yes. Thanks for the reply. If it was that simple it'd be done already. Getting all the other stuff off to gain access will take some time for me. Unsure if I'll have a crack at this as a bit time poor...I think I'll give the mechanics a call tomorrow. It had a recent service...hopefully they can take it in asap. (daughters car). -
3
P0356 - Ignition Coil 'F' Primary Control Circuit/Open
Last weekend, engine on startup was running rough. OBD2 Scan revealed a P0354 error code. Cause proved to be a loose connector to the ignition coil on cylinder 4. Quite some time ago, I had previously viewed a YouTube video about using a zip tie as a repair instead of replacing the connector with a broken clip. As an immediate alternative, I used a small shrink wrap to provide a more secure connection. Have to find a suitable zip tie as per the following YouTube video. -
1
-
5
Current Drain
Thx Gordo , car is locked and keys are kept inside our house a long way away from the car . -
0
Bolts needed for 1kd acessorues melbourne area
Bolts needed for hilux 1kd ftv engine finushboff bolts on can any one help -
5
Current Drain
Also if the keys are kept close to the 200 the system dose not go to sleep. Ray. -
0
Replacement Key for Kluger 2013
Hey guys I have a kluger 2013 KX-R (2WD). The spare key has been lost and I'm only left with 1 key at the moment which is asking for trouble I've been browsing around and would like to get a replacement from Aliexpress as the local prices from dealers etc are ridiculous. Happy to give programming a go myself On the key that I have, I can see the letter G. I've opened up the case but there are no numbers anywhere. So when I'm trying to hunt for a replacement, I don't know what chip is inside, what Mhz, and what Key cut is needed Attached is a photo of the current key/remote Any help would be much appreciated! -
5
Current Drain
Thx gents , auto elec has done all those things with no success . 👎
-
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now