Jump to content

TimBondi

Members
  • Posts

    1
  • Joined

  • Last visited

TimBondi's Achievements

Member

Member (1/14)

  • First Post
  • Conversation Starter
  • Week One Done
  • One Month Later
  • One Year In

Recent Badges

0

Reputation

  1. Hi, I only have one remote key for my Rav4. The key blade has a G on it's shaft. I've ordered some blanks from Ebay and I've seen all these strange instructions on how to reprogram a remote by opening and closing the car doors etc. I was wondering if anyone can confirm this works. I have a 2011 Rav4. The following is one set of instructions i found: Instructions: 1. With the driver side door unlocked and open slide the key in and out of the ignition twice without turning it. (Should be done within 5 seconds) 2. Close the driver side door and then reopen it, and then close and reopen it again. 3. Put your key in the ignition again and remove it. 4. Close the driver side door and then reopen it, and then close and reopen it again. 5. Put the key in the ignition and then close the door 6. Turn the key to the "On" position without cranking the car and then turn it back to the "Off" position and remove the key. ***If you are only adding an additional key fob to the vehicle turn the key to "On" position only once. If you are "Rewriting All Key Fobs" and clearing the memory, turn the key to "On" position twice and then remove the key 7. You should have heard the door locks cycle after you removed the key. This means the vehicle is in program mode. ** If the door locks did not cycle you will need to repeat steps 1-6 again, you should completed step 1 within 5 seconds. 8. To program the new Toyota Key fob hold the "Unlock" and "Lock" button on the key fob for two seconds and then release. Then press the "Lock" button for up to three seconds and release. The door should lock and unlock
×
×
  • Create New...

Forums


News


Membership