Hi Guys, A while ago I lost a set of keys with my car remote attached and called up my Toyota Dealer to get a price for replacement remote. They told me that it was $300 for each remote and an additional $33 to program each remote. I told them not to worry about it lol. I still needed a remote so I checked out eBay.com.au. I found a few listings and eventually purchased two remotes for $67 including shipping. They came the next day but obviously they didn't unlock my car so I had a look and found some reprogramming instructions. I had a go and it worked! All up, I had two remotes delivered and programmed to my car and all it cost was $67. Remember, Toyota would have charged me $666 ($300 remote x 2, plus $33 reprogramming fee x 2). I paid just over 10% of the price! Note: When I posted this there were no remotes for sale on eBay, but if you check the completed listings you will see that they turn up every fortnight. Be patient. Search for "Aurion Remote". Also, the Aurion will only accept 4 remotes in total. Reprogramming instructions: 1. Start with the key out of the ignition. Open the driver door (all other doors are closed). Driver door is unlocked (other doors don’t matter). 2. Perform these steps within 5 seconds a. Insert the key into the ignition (don’t turn it) Pull key out b. Insert the key into the ignition (don’t turn it) Pull key out 3. Perform these steps within 40 seconds a. Close, then open the drivers door. b. Close, then open the drivers door. c. Insert the key into the ignition (don’t turn it) and pull it out. 4. Perform these steps within 40 seconds a. Close, then open the drivers door. b. Close, then open the drivers door. c. Insert the key into the ignition and leave in the ignition. d. Close the drivers door Turn the ignition to ON (as far as you can go without cranking the engine), then back to off . e. Remove the key from the ignition. 5. Within 3 seconds, the power door locks should lock then unlock automatically indicating successful entry into programming mode. Return to step 1 if the locks do not cycle at this point. 6. Perform these steps within 40 seconds a. Press the lock and unlock buttons on the transmitter simultaneously for 1.5 seconds b. Immediately after letting go of the lock and unlock buttons, press the lock button by itself and hold for 2 seconds. Within 3 seconds, the door locks should lock then unlock once indicating successful programming. If the door locks cycle twice, repeat steps 6a and 6b as the remote was not accepted. 7. Open drivers door You're done! * I've taken these reprogramming instructions from http://www.programyourremote.com and they were listed under the US 2006 Toyota Camry Solara. It took me a few goes to find instructions that worked for our Aurion.