Jump to content

RODNZ

Regular Member
  • Posts

    24
  • Joined

  • Last visited

Profile Information

  • Gender*
    Male
  • Toyota Model
    was Runx Z, now a Caldina GT-T

Legacy Data

  • Location
    Hamilton, New Zealand

RODNZ's Achievements

Enthusiast

Enthusiast (6/14)

  • First Post
  • Collaborator
  • Conversation Starter
  • Week One Done
  • One Month Later

Recent Badges

0

Reputation

  1. similar incident http://forums.toyspeed.org.nz/viewtopic.php?t=88693
  2. did you resolve this? could be a fuel filter problem...
  3. In NZ, i saw these for sale; http://www.trademe.co.nz/motors/car-parts-accessories/performance/electronics/auction-400382509.htm maybe its the same part number?
  4. Oh yes I saw that, but doesn't show you where you take off the star screws and oil the bearings inside, should rotate freely inside. Just had to mark it so it lines up properly afterwards when you put it back together.
  5. I came across this thread on how to fully take it apart and clean it... http://matrixowners.com/?showtopic=65513
  6. Dutchie101, Thanks for the clarification mate. Planning on getting the HB4 kit for my ZRE sedan to test them out. If its too much glare hopefully they will fit my Dad's 07 Camry Grande, since the Camry comes with projectors already. Also another thing to rant about, how can a $40000 Camry not have HID standard!?! Recession
  7. your manifold has warped perhaps, stud will be broken off probabily at the end closest to your altenator check out this video
  8. after reading this thread I was curious and investigated my runx to see if it had one... and Yay my Runx came with a filter and it had some leaves with it
  9. From Japan, I guess theyre not made the same way
  10. I think the connectors are different, my Runx didnt fit aftermarket ones which were made for NZ corollas
  11. I would have thought windows came tinted from factory (except front sides) like my corolla.... guess not
  12. TBH I quite like that gearknob, nice to hold
  13. Well when I got my rear lip put on I had a choice of cutting the lip or get the exhaust tip rewelded, I went with the rewelded option. I got them to lower it and extend it so it now sits lower and extended a bit so the fumes dont mark the rear bumper I have a TRD High Response Muffler Ive seen rear lips here in NZ put over the back, looks as though the factory exhaust tip is pointed down and no modification is needed
×
×
  • Create New...

Forums


News


Membership