Search the Community
Showing results for tags 'Engine mounts'.
Hi, My partner has a 1996 2.8L Diesel Hilux the 4door steel tray back ute, and on idle it shakes the entire car, yet when in gear or throttle it will smoothen out. It didn't always do this. It started happening after the gearbox and clutch were replaced, and she thought it may have been the engine mounts so she got someone to replace them. What could be the cause of this? I feel it may be a timing issue, or that the gearbox wasn't fitted properly. When the car is in idle and I stand next to the engine it shakes and when I play with the throttle cable it smooths out. Any and all advice is welcomed please. Also, does anyone have access to an engine diagram or an engine manual for this car? I contacted my local super cheap and repco and they don't have anything. I've uploaded a picture of the engine if it'll give you any information about the case.
Hi Guys, I have a 1990 ST182 Celica AUTO with the 3SG-E engine and need some help with engine mounts. Going by the level of maintenance on this car, it looks as thought this thing has just been run to the ground. I am trying to restore it to it's former glory because I think they're cool and it's a shame to just disregard it as a POS! The front engine mount has collapsed and there is a vibration through out the car at idle, inside the cabin it just drones at idle! (I have never experienced that before in a car at idle). Question is, are all the ST18X engine mounts the same for eg, are 5SF-E and 3SGT-E the same as 3GS-E? I will assume that the engine blocks would all be relatively the same externally but I am not sure. From what I have seen at the wreckers, it appears the 5SFE mounts look the same as what's in the car now. Before I start buying mounts I thought to run it by anyone here that might know better. Any suggestions? Peter