noah_73

On 12/30/2022 at 4:41 PM, Henstepper said:

Ok so i bought my toyota aurion after listening to a lot of mechanics go on about toyota reliability. So far in the words of scotty kilmer mine has been an endless money pit. not only do things break often, when they do brake they are damn expensive to fix

 

My window wiper fluid stopped working, So here i was thinking it was just low on fluid. Fill it still nothing. Take it to toyota and they hit me with the motor not working that will be $600 for the motor and $150 an hour for labor and it takes 2 hours to fix.

 

i almost dropped to the floor. i declined the repair and swiftly walked out because in my mind i cant justify spending almost $1000 just for a gadget to spray water. How absolutely absurd!

 

Anyways toyota reliability? yeah not really.

 

/end rant

That is most definitely a rant but a failed washer motor and an obscenely high quote don't make a car unreliable. 

This is the plug that goes to it, so far I've worked that front door speakers are wired up to that amplifier but rears aren't. No idea about the two apparent tweeters in the dash but disconnecting it doesn't make a difference to the sound from it so I'm going with no for now.

My MY10 Presara has a factory amplifier under the drivers seat (see attached photos), does anyone have a pin out diagram for these. The internet has close to nothing on nothing.

I've installed Pioneer TS-A6960F 6 x 9's and they sound awful, I'm trying to get to the bottom of why.

14 minutes ago, socks2807 said:

Yeah its a 2009 Presara. 40 series. And the camera cable did have 4 wires coming from it. Honestly I can't tell you if it was a 24 pin or what because I didn't count and the car is back together again, but it was long and thin, definitely a 16, 18 ... 24 etc pin. I just cant tell if the harness I linked is exactly what I need or slightly different because it says its for the early 50 series, and has 16 pins. 

Go to https://stingeraustralia.com.au/product/axbuch-t26v/

Without being there I think that's what you're looking for, the one thing that leaves me with doubt is the picture of it given the number of wires it has coming from it. 

The camera harness could well be the 24 pin plug with 4 wires in it, what spec level is your car? I'm assuming it's a 40 series. 

You'll probably find that the Sony headunit requires a 12 volt camera while most Toyota cameras run on 6 volts. In other words it won't work unless you buy the appropriate Toyota camera retention harness or put a voltage reducer in.