andajo

Hi Does anyone know what could cause the problem below? I have seached the forum & thought it was either a clutch or gear selector cable problem common to the Sportivos but when i took it to Chatswood Toyota today they told me that they did not know what it was. They had the car on the hoist, took about 45 minutes all up to look at it - including 2 test drives. The problem is a rattling/buzzing type of noise when the car is in rolling/decelerating in gear with foot off the clutch. If I accelerate again, the noise reduces. If I push the clutch in fully, the noise stops. Also, when the car is stopped and in neutral, I get the same noise if I rev the engine to 3000-4000 rpm. This noise stops if I push the clutch pedal in fully. Thanks for your help.

Thanks for the responses everyone. I fitted it last night. Drove the car this morning - very happy with the result. Problem was that I was trying to fit the intake tube over the wiring loom that runs from from the fuse box to the engine so there was not enough room because the wiring loom was holding it back. Ended up lifting up the wiring loom and slipping the intake tube under the loom and it went in quite easily.

Hi i just bought an Injen CAI for an 04 Corolla Sportivo. The part number is RD2075 as listed in the parts number section of the forum. I am having a lot of trouble fitting / lining up the intake tube. Has anyone fitted one of these and can give me some hints or know of a workshop in Sydney that can fit one. I have followed all instructions given by Injen but just can't manouver the intake around to get it in the right position. Also, if you have fitted a TRD intake, is it very hard to position the intake as well? Thank you