Hi all, this is my first post on this forum. I hope someone out there will have an answer to this question. I have a 1983 Tarago which originally had a 2C motor (diesel) which finally died. I found a replacement 2C-T (to increase the usefulness of the vehicle) through Brisbane Motor Imports and was assured that the engine mounts were the same as the 2C since both were in the warehouse at the time and were compared in situ. However the right engine mount has the chassis bolt slot approximately 35mm forward of the old mount. The old mount will not bolt to the block because the curve in it is up against the oil filter extention on the filter housing (where the turbo oil is taken from), which is facing down to fit around the turbo. Where can I find a right engine mount to suit? Alternately, could the oil filter extension be re-arranged? Thanks in advance.