Corolla front end links

[3zzfe]

Ciao,

can you help me to find the swaybar fron end links for my Corolla E12 (european 3ZZ-FE engine)?

have you some websites where I can find them?

[SuperDave]

http://www.nolathane.com.au/

These guys do some, part number: 42702 for 63mm ones.

[3zzfe]

yes the part number: 42702 is listed for corolla zze122

I saw also the part number 42790 that allows to cut it and fit it.

would be acceptable?

Thanks SuperDave ;)

Edited January 29, 2009 by 3zzfe

[SuperDave]

Part number 42790 would be fine, however you'd want to make sure the weld is good.

[3zzfe]

I've contacted nolathane.com.au and they redirected me to Whiteline UK

It seems that their end link part number W23180 it's ok for my corolla.

My doubt is on the length, it measure 63mm....a little short..... or not?

[SuperDave]

I haven't measured the stock end links, but they are only intended for cars that have been lowered by a lot. It's so you can keep the anti roll bar ends clear of the sub-frame and lower suspension arms. For a rough estimate measure the stock end links and subtract how much you have lowered your car by, if it is close to 63mm then sounds about right.

Whiteline UK must be the distributor for Nolathane in the UK.