Jump to content


Jays AE82 4AGZE


JayMan

Recommended Posts

hey all,

picked this up a couple weeks ago with plans of neatening it up and working the little nugger.. took it straight to Jason. .(GATFXGT) to seek his tick of approval.. which i have since gained seems to have ALOT of problems as it was a very dodgy install. the car idles extremely high and the c52 gearbox isnt helping in the wet.. iv since learnt to only take off in 2nd gear with very light acceleration haha. needs endless amount of work. the interior is terrible and the wiring is a mess. needs new brakes all round and some bolt ons

keep your eyes on this spot!

Owner: John

Car: AE82 Corolla Twincam 16V Hatch (87 series1)

Engine: AE101 4AGZE MAP

Engine mods: stock

performance: 14.9 sec quarter mile

Drive train: stock c52 LOL!

Suspension:stock

Brakes: stock

Bodywork: needs work

Wheels and tyres: stockys

Interior: A BLOODY MESS!

stereo gear: super charger whine!

Future Plans:

LOL.. ask me in a few months after i restore the bloody thing

Link to comment
Share on other sites


and how the car looks now

P6210068.jpg

P6210069.jpg

P6210070.jpg

P6210071.jpg

since i have had the car i have done quite a bit of work

*created my own fused an switched circuit for instrumental lights as there seems to be a cable fault

*replaced the whole dash with an undamaged un molestered item

*put twincam stockers on with new rubber.

*changed bucket seats which were mounted on BLOCKS OF WOOD! to twincam seats.

*replaced windscreen wiper mechanism

*GHEY CANNON has been removed!.. the flange just before it had been removed and the cannon had been welded on. i cut it up and pulled it off to find the CAT had been punched out. i replaced it with the standard cat back off Daisy the old car.

*replaced drive shaft and box oil

*replaced thermostat and radiator for safe measure

Link to comment
Share on other sites

went on a cruise with

an STI wrx 02

ford xr6 turbo

skyline R34 gtst

and an S14 200sx

all slightly worked.

got to the end of my street and realised my speedo cable wasnt plugged in. so i fixed that and we drove to a car wash where we waited for one of the boys to arrive. my windscreen wipers were not doiung a good job and when i looked into it.. i haddent tightened up the 3 10mm bolts around each wiper haha so i did them up. . then doing a uturn within the car wash i hear clunk and a grinding noise LOL i thought i did the box..

ends up being the left drive shaft shattering. so 2 mates went to their workshop to get tools and another 2 came to my house to get a shaft. under the shelter and light of the car wash bay i jacked the car up and remover the wheel. lossened the bolts and then we changed the shaft haha!

we had no gear box oil so we re used the old stuff and used automatic transmission fluid to fill it up. went to maccas and ate. then 5 minutes into our trip home i come to take off at a set of lights and the car wouldnt go. turns out my shaft popped out from the gearbox side :S so we got it back in and made sure it stayed. and i drove home with no gearbox oil haha.. i dont know why it popped out but ill look into it during the day

its boosting to 10 PSI but i know theres a leak or two and theres also a vac leak. on idle it sits at 14psi on my gauge. the car idles very high maybe 2grand. the reason the car was so jerky was because the TPS wasnt screed in! and its half ripped apart! ill have to replace it and tune it

21062009104.jpg

the workshop ;)

20062009093.jpg

munched! :)

20062009095.jpg

the souviners

20062009096.jpg some of the other partys on the cruise

20062009098.jpg

21062009101.jpg

Link to comment
Share on other sites


I think all it needs a little loving. I'm sure you will be able to sort it all out, hopefully without breaking the bank.

I guess once you get it into a decently drivable state, things should start to fall into place.

who can pick whats wrong with that super charger pulley :P ?

My eyesight is not the greatest, but to me it looks like the pulley is slightly off axis.

Link to comment
Share on other sites

yeah it does need ALOT of TLC but i do have 2 x ae82 twincams and plenty of parts to fix her up! just need some spare time.

the supercharger clutch pulley must have failed so the previous owner has spot welded it together to keep it engaged constantly haha!

Link to comment
Share on other sites

lol thanks Damo. im fairly confident ill have it running smoothly enough tonight to enjoy her and then ill continue on ironing out the minor bugs.. . like the pathetic fuel economy.. 200kms to a tank!!!!

Link to comment
Share on other sites

ok i resealed the supercharger outlet and it fixed the idle! :)

did the ABV mod

did an oil change with penrite HPR30 and ryco filter

changed the thermostat and changed housing to one in better condition

Link to comment
Share on other sites

ok its official.. this car actually goes better with boost leaks h34r: think i blew out the gasket on the supercharger outlet again.. i only had cork gasket so i used it temporarily just to test my theory that the leak was causing the high idle.. so now i need to fix that.. transfer the car into my name and pay for insurance lol so much bloody ***** at one time! grrr

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.




×
×
  • Create New...

Forums


News


Membership