hilux mk7 2012

[Leny]

Hi, I i live in Inverness, Scotland and I have purchased a 3 /4 bench seat from Perth JTW Breakers  - really helpfull guys.  I  am doing a 3/4 bench seat conversion to my 2012 hilux mk7 single cab 4x4 .  I need help with the lap belt fittings.  Can  any one help?  photos etc would be a great help.  I have located the 2 front holes for the seat and hoping to find the rear holes when I start drilling.  Are the seat belt fitted under the seat holder brackets or through the floor pan ? Thanks.

[CONROD]

On my little workmate when I swapped the bench out for a bucket and 3/4, the holes for the seat belts are already there in place with captive nuts attached under the floor pan, they had a very thick adhesive like sealant tape overtop of the hole to seal it from dust/water. Climb underneath and look up in the transmission tunnel where you feel the seal belts will be and you should see one eitherside 

[Leny]

thank going to have a go tomorrow thanks

[Leny]

thanks conrod for the info now fitted jumped into the truck fell into the passenger side forgot no cubby arm rest to lean on  ha ha looks good though

[Leny]

[Leny]

[Leny]

[Leny]

[CONROD]

Good to see, I like that side pocket on the side of the console, was that an aftermarket or an original Toyota accessory in your part of the world. A bit off topic, sorry Mods, how much a litre of fuel are you paying over there? We are paying around $2 cpl for e10, $2.36 for diesel give or take 

[Leny]

Side pocket after market  - from ebay. Painted console and pocket with grey stone chip console from a double cab.  Cut and filled with fibre glass and filler. £1.89 a ltr,  I think 338.53 in your dollars.  Hard frost this morning - not good for roofing.