Power board fitment

[Gary Chapman]

I have a 76 and on the right hand barn door considering wiring in a Kings power board wondering if any one has tried this.

I was wondering if recessing it into the door itself, it appears you would have to cut some sheetmetal  and obviously cut door card.

If you cut sheetmetal would it affect the doors integrity.

I think it would be a convenient place and save space.

Any suggestions. 

Gary Chapman

[Gary1964]

The door is manufactured in its original form for maximum strength, I feel cutting into it is not going to be much of a huge issue, unless you get extremely hard from the rear in which case the door would be totalled anyway, You could try and install some reinforcement around your power box.

[Gary Chapman]

Thanks for reply,from what I can tell a third of door is blank,if you cut out Place for power board you could possibly make some tabs that are from the original sheet.As you say i.did wonder about the integrity of door.