Reverse gear sensing wire

[czaja74]

I'm installing reversing camera in my wifes '04 Altise. I need to connect reverse gear sensing wire. I spend hours on the net trying to find wiring diagram showing which connector and which pin I should connect it to but no luck. It will be great if somene could point me in the right direction.

[carly1]

I'm installing reversing camera in my wifes '04 Altise. I need to connect reverse gear sensing wire. I spend hours on the net trying to find wiring diagram showing which connector and which pin I should connect it to but no luck. It will be great if somene could point me in the right direction.

U may try this: 1) turn the key in On position (but don't start your engine) and set the gear to R 2) find out the the reversing light connector at the boot 3) test connector with meter, the reading should be 9.6~16V

Hope this help

Edited May 1, 2010 by carly1

[czaja74]

It is on the driver side where fuses are. Its pin 3 red wire.

[bigbass]

why dont you take out the rear tailight and get it from the reverse bulb wire ?

[DJKOR]

why dont you take out the rear tailight and get it from the reverse bulb wire ?

Less wires to run and it would reduce clutter.