Jump to content


Bigpete

Regular Member
  • Posts

    143
  • Joined

  • Last visited

  • Days Won

    5

Posts posted by Bigpete

  1. Sounds like adjustment you have adjustment under your centre consule at the y junction and adj at your rear brakes or failing all that the cables are streched beyond adj need to be replaced

  2. On 10/26/2019 at 7:21 PM, Bigpete said:

    Hi All 2012 Hilux  . Has anybody fitted rims from a prado original rims to fit a hilux should be a 7.5J ET 30  17 inch

     reading these are off of Prado 120 was wondering if the 150 version would fit

    Got it all sorted thanks!.  Got Prado rims fit great   

  3. Hi All 2012 Hilux  . Has anybody fitted rims from a prado original rims to fit a hilux should be a 7.5J ET 30  17 inch

     reading these are off of Prado 120 was wondering if the 150 version would fit

  4. Get the code prob going to be a p400 low egr gas flow  just been through all this crap mine was clean enough not to throw codes ended up being a vac hose 

    but if you are going to explore go to Forby4diesel check out cleaning the egr system got some good vids on there give you some good info and tips if you are going to have a crack yourself 

  5. Hi  EGR is a crap system but because of the computer it must work

    firstly get a vacuum guage check the pump then work your way through the system ,with these things its working your way through the system

    could be a hose ,electrical ,or even check the o ring at the egr position sensor just gotta check i

    is it throwing any codes ?

     

    • Like 1
  6. Sounds like you have an earth issue only the spotlight will be earthed ,Not the relay 

    Rember  toyotas are switched to earth  if you put a test light on to the wiring it will power up with any switch in the off position   

    Use the wiring code i gave picking up power from the l/h headlight use a test light to confirm power souce works on both of my Hiluxs
     

  7. 4 pin relay

     86 High beam  connect red wire yellow trace at back of headlight

    30 + 12v  source battery fused

    85 switch from the red wire on the back of the light through the switch back to terminal 85

    87 spotties better to run wires from each light earth under the bonnet and get a relay with two 87 terminals just easier and neater

    use 4mm wire

  8. Hi I have a 2012 KUN Hilux  ,It threw a code po400 EGR low gas flow being a x mine vehicle thought it may be chokkers with crap

    Got in there was only a coating of a couple of mil ,cleaned it out refitted light came on again checked the egr butterfly valve .

    Removed the egr position sensor needle stuck covered in dust replaced the o ring now waiting to hopefully never see the light again

    anybody experienced this issue

×
×
  • Create New...

Forums


News


Membership