Jump to content

FL Hub - 2003 Corolla Sportivo

tiet

By tiet
in Corolla / Corolla Sportivo Club

 Share

Recommended Posts

tiet Veteran

tiet

Posted
Posted

hi, i drive a 2003 corolla sportivo,

my front left hub holding the wheel is extremely loose,

i was wondering if you could tighten it, is it possible to do it yourself? or do you have to replace the whole hub?

if so how much would this cost?

thanks

tiet.

Link to comment
Share on other sites

robie Mentor

robie

Posted
Posted

take it to a dealer get a new wheel bearing n hub asembly get them to press the old bits apart n press the new bits together theres not other way an if i was u id do it asap

Link to comment
Share on other sites

CHA54 Grand Master

CHA54

Posted
Posted

a new bearing is ~$80 from CBC, the actual hub (The part that presses into the bearing center) shouldn't be that much more. You shouldn't need to replace the carrier that the bearing race presses into, and you'll only need to replace the actual hub if the bearing has spun on the hub and gauled the shaft surface.

Re-pack the new bearing with some good high-temp wheel bearing grease, take it to a mechanic and it should taken them less than an hour labour to replace it if they know what they're doing.

Link to comment
Share on other sites
tiet Veteran

tiet

Posted
  • Author
Posted

well hopefully i don't have to get set back $600+, if its only going to cost me $200ish i'd be happy with that, thanks for the replies everyone,

if anyone else has an idea please post :)

i will post details after my friend checks it out when he has the time, i want to be completely sure what the problem is, i dont want to get ripped off lol

Link to comment
Share on other sites
tiet Veteran

tiet

Posted
  • Author
Posted

ok found out the problem, some how the big nut in the middle came loose the one that holds the whole unit thing to the drive shaft, you know the big bolt in the middle of the stud pattern. not sure how it came loose but it did, tightened it and sounds gone thanks for all the help though

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing



  • Join The Club

    Join the Toyota Owners Club and be part of the Community. It's FREE!

  • Latest Postings

    1. 1

      help with clutch

      Hi, so the 12r engine is a easy bolt in where rh11 was did you ever put in a more modern engine arfter the 12r ???. thanks
      johnxb351 in New Members Introductions
    2. 3

      newbie from Queensland

      What was the cruising speed of your rh11
      johnxb351 in New Members Introductions
    3. 1

      High mileage camry

      Nice one Preston, keep her well oiled with fresh oil and she'll give another 300k
      Steve in New Members Introductions
    4. 0

      1981 Hiace ignition upgrade

      Hi All I'm looking at buying a 1981 hiace petrol it has the old points ignition. I'm hoping a newer electronic distributor will fit from a newer engine. Dose anyone if this can be done .
      johnxb351 in General Toyota & Other Car Discussions
    5. 1

      Buying 3rd hand 2010 Aurion Sportvio for $9000

      That is about the standard price you'd expect nothing crazy, I paid pretty much the same for a 2008 model with 160k on the clock. As to the high km's and maintenance, 165,000km for a Toyota is nothing to sweat about and the maintenance/repairs are pretty cheap. If it's been treated well by the previous owners and you continue to look after it then it will easily last you another 5 years.
      CitrusZyn in Aurion / TRD Aurion Club
    6. 0

      Removing low beam bulb 2014 Camry

      I apologise if this is an idiotic question--I've searched and watched dozens of videos on how to replace a burnt out bulb, and i'm fine with it (i've even done it before, though it was years ago). the problem is that I can't seem to get the bulb out of the 'plug'/base--it seems that that is too blindingly obvious to be explained or shown on camera. I can't remember what I did last time I replaced a bulb... I don't know if I have to push something on the fitting to release it, if i have to twist it, or just yank really hard. I've applied as much strength as I dared, but am afraid of breaking something if i try to brute force it out. I could just pay $15 for someone at supercheap to pop it out and replace it for me but it's become a matter of principle at this point... I'm unwilling to admit defeat. The photos below are from a different post on this forum, but they're the same exact kind of bulb/fitting i'm struggling with... Any tips would be much appreciated. My wife is getting really annoyed with me because we can't drive at night but i'm too stubborn to pay $15. Thanks!
      Markamry in Hybrid Camry
    7. 0

      94CamryGreen

      DominikR in Member's Gallery
    8. 0

      Aftermarket Air Intake

      Hey all, Just recently bought a 2007 TRD Aurion and am trying to find an aftermarket Air Intake, but am coming to the realisation that there is a very limited market for TRD Aurions. So far the only system I've been able to find is a K&N Typhoon Intake (link here: https://www.carmodsaustralia.com.au/KN-Filters-69-8611TS-69-Series-Typhoon-Performance-Air-Intake-System-Camry-35L-07-11?cq_src=google_ads&cq_cmp=18898892770&cq_con=&cq_term=&cq_med=pla&cq_plac=&cq_net=x&cq_plt=gp&gad_source=1&gclid=Cj0KCQjwpZWzBhC0ARIsACvjWRP893VLnAQsxIZJjcW5Go75b_T2N25rSWBVu6IeDziM2v41bpeyOREaAg1fEALw_wcB), however when viewing specifications for the product it states it fits Camry's from 2007-2011. Further digging revealed this product is an import from the USA hence why it's for a Camry - they don't have Aurions there. I am aware that they both share the 2GR-FE engine so I'm assuming the product will be able to be retrofitted to my TRD, provided the throttle body intake is the same diameter across Supercharged 2GR-FE's and N/A 2GR-FE's. Has anyone else in Aus had any luck sourcing/fitting one of these K&N Intakes, or know of another brand that do them specifically for the TRD Aurion's. Pretty confident in just ordering the aforementioned kit but their return policy sucks (can't return and refund if packaging has been opened, etc). Cheers guys! Jason.
      BigJasoM8 in Aurion / TRD Aurion Club
    9. 0

      Heater problems

      My Toyota Celica SX blows cold air at the driver’s side when the heater is on, and it is an absolute nuisance. I get that it takes a while for the heater to work properly, but some reason after I have the heater on, it starts blowing out cold air even after a good warm up! I feel like the heater core may need replacing or the air conditioner/heater needs re-gassing.
      Angrysubie64 in Celica Club
    10. 0

      Entertainment Unit Upgrade

      Hi everyone. Just after some advice on head unit upgrade. I'm looking to upgrade the functionality of the entertainment system to do a few things - display my dual camera from my caravan, utilise the HEMA OnRoad/OffRoad module, stream to the rear screens, and include wireless apple play. I've narrowed down to the most popular which seems to be Advanced Ice, EC Offroad and Galios - but none seem to do all four functions seamlessly. Not sure if I'm actually looking for a unicorn or not...has anyone had any experience in installing one of these systems and has it done all the functions? Any regrets? Cheers Mark
      margro in Landcruiser Club
×
×
  • Create New...

Forums

News

Membership