ZRE lights and specs required

[Ggergalicious]

After many hours of searching and being lazy to grab the manual out of my Corolla ZRE152. i decided to post this for my fellow lazies !!! lol

Exterior

---------------------------------------

Headlights:

Low beam (HID only) x2 - D4S Discharge bulbs (35W)

Low Beam x2 - H11 (55W)

High Beam x2 - HB3 Halogen (60W)

Front indicators x2 - Wedge base (5W)

Front position lights (Parking Lights) x2 - Wedge Base (5W)

Front fog lights x2 - H11 (55W)

Front indicators x2 - Single End bulbs (21W)

Tail lights x2 - Wedge Base (5W)

Stop Lights x4 - Wedge Base (16W)

Reverse lights x2 - Wedge Base (21W)

Rear indicators x2 - Wedge Base (5W) Orange

Side Indicators x2 - Wedge Base (5W) Orange

License plate lights x1 - Wedge Base (5W)

Interior

---------------------------------------

Vanity x1 - Wedge Base (8W)

Interior light x1 - Double end (8W)

Personal lights x2 - Wedge Base (8W)

Luggage Compartment x2 - Double end (5W)

Descriptions :

Wedge base ... T10 globe

HB3 ...

H11 ... also known as HB4

Double end globe .....

Single end bulb .....

Hope this helps ... :)

Edited October 5, 2010 by Ggergalicious

[dutchie101]

Might pay to put the Wedge size next to the corresponding light with its size to make things easier.

Reverse lights are T20 wedge

Rear Parker are T10 wedge

Front Indicators are PY21W (also another corresponding number)NOT the ones you have shown in the pic, but are the offset pin type (euro type)

Front fog are H11

Double end are know as "Festoon" and i think teh Dome is 31mm from memory.

Great idea to put it all together!

[Ascendant Rice]

Might pay to put the Wedge size next to the corresponding light with its size to make things easier.

Reverse lights are T20 wedge

Rear Parker are T10 wedge

Front Indicators are PY21W (also another corresponding number)NOT the ones you have shown in the pic, but are the offset pin type (euro type)

Front fog are H11

Double end are know as "Festoon" and i think teh Dome is 31mm from memory.

Great idea to put it all together!

hey dutchie, would LED's in the rear parkers work?

[dutchie101]

hey dutchie, would LED's in the rear parkers work?

Yep should be fine, as long as the diameter is no larger than say 11mm. 5050 SMD type will fit. Flux type probably wont as the bump or lens on the chip increases the total diameter.