2002 Camry 3.0P V6 ALTISE SEDAN: HELP With Keyless Remote Programming

[alice1111]

I've just bought a new blank remote for my Toyota

Does anyone know how to get it to programming mode?

I've found some instructions online but they don't seem to be working

is getting into the programming mode different for Australian built altise models? 

if I go through the steps , the car lock won't cycle ... 

the instructions found here was 
1. Driver door open and unlocked. Key out of the ignition
2. Insert the key and remove 2 times in 5 sec.
3. Close and open driver door 2 times in 40 sec.
4. Insert the key and remove it again from ignition.
5. Close and open driver door 2 times in 40 sec.
6. Insert the key in ignition, 
7. Close the door, 
8. Turn to on and back to lock in 1 second intervals. 1 time for add, 2 times for rewrite, 3 for confirmation 5 for prohibition. (yes, there is no “4”)
9. Remove the key
10. Power lock will cycle to confirm 
11. For add or rewrite mode within 40 sec of the confirmation, 
A. press “lock” and “unlock” buttons of the FOB at the same time between 1 and 1.5 seconds. 
B. within 3 sec press “Lock” button for more than 1 sec and release. 
C. If it’s correct, the power door lock will cycle once. If it’s wrong the door lock will cycle twice.

[texasflysuperstar]

Hi, I recently did this also for our Aurion. I found a bunch of methods and was willing to try them all. This very one that you have the steps for worked for me. luckily it was the 3rd one that i tried. I found that you have to be spot on with your seconds counting for it to work, memorising it will make it smoother. 

[Ronnyboy]

From memory, (this is for the two button Genuine remote) you need to put the key in the ignition and turn it from "OFF" to "ON" 3 times finishing it at "ON". If successful, the word "PROG" should come up on the clock and you should be able to program the remote by clicking on the buttons on the remote. Once done, you can remove the key. 

This function erases existing remote settings so before you remove the key you will need to press the buttons on the existing remote to program it.