Corolla Headlights for HID

[Romp]

Im just reading through the installation of my HID kit

Did anyone actually drill any holes when they isntalled their HID kit for their Rolla ?

It says ineed to drill a 22mm hole in some plastic cover thingy for wires to go thru.

Also Where did you guys attach your ballast??

[Romp]

Alright i got NFI

lol

$50 to anyone who can install it for me

[ZAV]

no drilling needed, you just need to be able to close the rear headlight cover. Just use a stavley knife n make two notches in the edge of the rear of headlight where the cover sits to fit the wire, then put the cover back on. If u lived in melb id do it for free.

But just to warn you the 6000k kit is a bit bright, sorta scared the cops will pull me over. I'm thinking about drpping down to 4300K. But yeah if any1 is interest in a 6000K kit PM me.

Edited April 14, 2006 by ZAV

[Romp]

no drilling needed, you just need to be able to close the rear headlight cover. Just use a stavley knife n make two notches in the edge of the rear of headlight where the cover sits to fit the wire, then put the cover back on. If u lived in melb id do it for free.

But just to warn you the 6000k kit is a bit bright, sorta scared the cops will pull me over. I'm thinking about drpping down to 4300K. But yeah if any1 is interest in a 6000K kit PM me.

so u just cut it near the edge so the wires go thru ???

where abouts did u mount the passenger side ballast? did u bult it to the chassis or did u just use the wire ties? and look it thru holes?