c-one eye lids

[bLk-StIvO]

hello

i dont know if anyone has had the same problem with the c-one eye lids as i have had but when i put them on the bottom edge of the eye lid would not sit flush down onto the light

i used some doble sided tape i got from autobarn

any recommendations?

and have you had the same problem i dont wanna bend them im afraid i might snap them and now im worried that they will slowly weaken off after a few washes due to it not sitting flush

[TRDYUS]

You need to be careful with them, line up both the top and sides before pasting down.

Maybe take the headlight off so it's easier...

Removing them is relatively easy, just lift up one side then the other until you feel it peal off a little & go gradually in turn on both ends.

It wont snap off if its done bit by bit.

Hope that helps.

Edited October 3, 2007 by TRDYUS

[BigBum]

Use 3M Tape and nothing else if you're worried about them coming off in the future :)

*Moving to Inside & Out