ES motor mount inserts

[reusch]

Hi guys, looking for some advice please. I've had these inserts installed for a while now, but only recently noticed that the rear one is sticking out quite a bit on one side..I've attached a pic, but is it just me or does it look quite bad?

Returning to my local garage to get it popped back in, but will it happen again?

I've read others have experienced the same problem and remember someone said they used custom washers to hold it in place? Can anyone explain a bit more?

Cheers,

Aaron

[CHA54]

get a massive washer made for each side so the mount insert can't physically pop out.

[Kenshin X]

its not "bad" as its still doing its job. yes it will happen again if u dont put in the washers like CHA54

this happened to mine but i ended up taking it out and storing it til next time when i put them in, i will do it properly

[reusch]

Thanks for the replies. So is it ok to keep it like that for the meantime? Will it cause any wear or damage to anything?

Cheers

[Kenshin X]

Thanks for the replies. So is it ok to keep it like that for the meantime? Will it cause any wear or damage to anything?

Cheers

if u wanna keep ur inserts yes, take them out. they wont damage anything since they are just inserts. the actual engine mount bushings weren't touched when they install it. they just loosen a bolt and insert those inserts in and put the bolt back.