Jump to content


sluggish starting

SCOOTA44

By SCOOTA44
in Aurion / TRD Aurion Club

 Share

Recommended Posts

SCOOTA44 Grand Master

SCOOTA44

Posted
Posted

I have had trouble with starting, it initially starts like its on 3 cylinders for about 10 seconds then runs fine. occasionly it does it at operating temp as well. I have recently replaced the plugs and its been the same from changing over the airbox to the SRI???? any clues??

450HP/tonne Mentor

450HP/tonne

Posted
Posted

VVTi controller on one bank not being at the correct alignment? Are you out of warranty?

SCOOTA44 Grand Master

SCOOTA44

Posted
  • Author
Posted

VVTi controller on one bank not being at the correct alignment? Are you out of warranty?

Thats quite interesting,it makes a horrible rattling racket when it first starts up, maybe its one of those. I know the mech removed the rear left one when changing plugs. I did notice it had a bit of sludge in it. Maybe take them all out and clean them.

450HP/tonne Mentor

450HP/tonne

Posted
Posted

That would be a quick check, but I was talking about an internal part; the first or fourth items in the parts list here.


SCOOTA44 Grand Master

SCOOTA44

Posted
  • Author
Posted

That would be a quick check, but I was talking about an internal part; the first or fourth items in the parts list here.

Thanks for that, will get it checked out next service, expensive parts to replace, dont want to bust any.

SCOOTA44 Grand Master

SCOOTA44

Posted
  • Author
Posted

I will be making a start on it by replacing the overdue fuel filter, see if that improves it.

SCOOTA44 Grand Master

SCOOTA44

Posted
  • Author
Posted

I will be making a start on it by replacing the overdue fuel filter, see if that improves it.

Good news it seemed to be the fuel filter, its starting a lot easier !

Adamsy Grand Master

Adamsy

Posted
Posted

Thats good news Scott, good news! how much for the filter?.

SCOOTA44 Grand Master

SCOOTA44

Posted
  • Author
Posted

Thats good news Scott, good news! how much for the filter?.

The filter cost $50.88 .

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing



  • Join The Club

    Join the Toyota Owners Club and be part of the Community. It's FREE!

  • Latest Postings

    1. 0

      2017 Diesel d4d toyata hiace limp mode

      Hi i have a 2017 d4d toyota hiace purchased from new I am currently experiencing issues with my van It seems to be blowing dark black smoke apon acceleration and is very laggy under foot also No fault code on the dash but i have a a fault code of p1608 Lack of power code come up on my mechanics scanner Both my mechanic and toyota have no idea what the issue is
      JPE Services pty ltd in Toyota Commercial
    2. 1

      Tyre Sale Specials

      Tried to search prices on mycar website & nothing would load Tyroola also has 15% off site wide. Some good prices depending what your looking for https://www.tyroola.com.au/
      L4WL3SS in Club Lounge
    3. 0

      overheated engine

      I drive a 2010 series 200 sahara V8 automatic. I recently towed a small caravan on a not that hotter day. The temperature gauge went to about half then dropped back to normal. The motor then went into limp mode and eventually stopped. On lifting the bonnet i noticed the top radiator tank had split all the way across. I have only two months ago had the complete cooling system checked with no defects. I called the RAA in South Aust and they tried to start it but just turned over but did not fire up. It was still pretty hot. I have been told the motor would be ruined by overheating. The car has been sitting at the repairers for 5 days now and as far as i know it has not been attempted to start. Before putting a new motor in it would it be worth putting a new radiator in it and see if it will fire up? Open to any suggestions at this stage.
      wayne m in Landcruiser Club
    4. 1

      1996 Trueno XZ - Is it worth modding?

      Depends on how common/rare they are in your part of the world. The XZ trim was the second-lowest so didn't come with most of the fun bits that the full-fruit BZG/V/R models did, so it's not anywhere near as desirable stock but sometimes you have to make do with what you can find, plus you shouldn't feel as guilty modding the heck out of it since most of it isn't special.
      Hiro in Classic Toyota
    5. 62

      VSC, Traction Control, Check Engine lights all on

      I attended Toyota Preston for Aurion ATX 2013 major service today. Cost $~$1300. On the way home I stopped to pick up dinner. Two fault lights: engine and VSC lights came on when I restarted the car. Car drove home just fine. I can only return the car tomorrow for them to sort out. Annoyed. Let’s see if they’re still on in the morning.
      57John in Aurion / TRD Aurion Club
    6. 1

      1996 Trueno XZ - Is it worth modding?

      Hi everyone, new member to the group and owner driver of a nifty little Toyota Sprinter Trueno XZ, now this was my cousins car, I bought it off him and after various drives, I have come to the decision that this needs alot of love. Now I am wondering if its worth putting my time and money into doing this certain make n model up or should I just buy a different car to do up? I am not very car-inclined so I really don't know a lot. Any opinions would be very helpful Thankful!
      Danimal in Classic Toyota
    7. 1

      Query about the correct rotors for 2006 ACV40 Camry.

      I did a Google search. RDA 8112 suits your vehicle: TOYOTA CAMRY ACV40R 2.4L 2AZ-FE DOHC 16v MPFI 4cyl 117kW 5sp Auto 4dr Sedan FWD [06/06 – 09/11] TOYOTA CAMRY ACV40R 2.4L 2AZ-FE DOHC 16v MPFI 4cyl 117kW 5sp Man 4dr Sedan FWD [06/06 – 09/11] RDA 8112 Specifications: Specifications: Centre Hole Diameter: 62mm Flange Diameter: 62mm Minimum Thickness: 25mm Type: Vented Height: 49.2mm Diameter: 296mm Item Type: Disc Brake Rotor Material Type: Cast Iron Thickness: 28mm Pack Qty: Pair Stud Holes: 5 Position: Front RDA7686 RDA Brake Rotor 296mm x 26 Min (151mm Outer Hat Dia) Type DISC BRAKE ROTOR Brand RDA BRAKES Unit of Measure EACH Description RDA Brake Rotor 296mm x 26 Min (151mm Outer Hat Dia) Warranty 12 Months 20000kms Centre Hole Diameter 62mm Minimum Thickness 26mm Type Vented Note 151mm Outer Hat Diameter | (Use RDA8112 for 155mm) Height 50mm Diameter 296mm Item Type Disc Brake Rotor Thickness 28mm Number of Stud Holes 5 Position Front Brake Disc Type Vented Brake Disc Thickness 28 Centering Diameter 62
      campbeam in Camry Club
    8. 1

      Tyre Sale Specials

      I have been waiting and hoping for this Black Friday sale special to appear for 2024. 50% off all Pirelli Tyres. Main qualifying sale condition is: "Offer Tyres must be booked on Friday 29 November 2024 and be fitted between Monday 6 January 2025 and Saturday 15 February 2025." https://www.mycar.com.au/blackfriday?gad_source=1&gclid=Cj0KCQiAuou6BhDhARIsAIfgrn6ZbAnmv-FBFyT5UjZ5s9kCnKFSoMQLrVk3KXff7IqWPqq56qzU7oMaAr-eEALw_wcB&gclsrc=aw.ds
      campbeam in Club Lounge
    9. 10

      Android auto

      OK. Does any of Toyota's advertising material mention Android Auto? If so then kick up a stink, with Toyota management, about misrepresentation and false advertising, reminding them of the hefty fines. Herb
      ozieagle in RAV4 Club
    10. 0

      E160 Corolla fielder suspension

      Does any one know if the trd sportivo suspension for the 2017 facelift corolla fielder fits the 2013 prefacelift version? Is the chassis the same? Thanks for the help.
      jay886 in Corolla / Corolla Sportivo Club
×
×
  • Create New...

Forums

News

Membership