Jump to content

Recommended Posts

Posted (edited)

Purchased this the other day for $500 obviously it needs some work but it will be a new project for next year :D

 

Its only done 179,000 k's and has a 3.0L 7mge motor.

The interior is a little rough but im hoping to get it looking like new again. Its got the electric rear reclining seats and a cooler box on the parcel shelf.

The exterior needs abit of works but finding parts is near impossible.

 

iz5kde.jpg

http://b5nq5s.jpg

 

Edited by Sportivo_05
Posted

I am very much a believer in preventative maintenance. Therefore, I would be keen to do a complete oil change of the engine, transmission and differential. Used oils can become acidic. Engine oil sludge can be an issue for low mileage vehicles. It should be less of an issue in pre 1990's vehicle with fewer vehicle emmission controls but always best to check. Easy way to check is to remove oil filler cap. Not expecting this, but if there appears to be lots of oil sludge, I would then also remove the valve cover/s and the oil pan for a thorough clean and to check that the oil pickup screen.

Personally, I would drop the engine oil and then put in about 5 litres of diesel. Idle the engine for 5-10 minutes. If necessary, repeat before new filter and engine oil. I have been doing this procedure for many years.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Join The Club

    Join the Toyota Owners Club and be part of the Community. It's FREE!

  • Latest Postings

    1. 18

      High idling on the 2zzge even when warm (solved!)

    2. 5

      High RPM Idle after the engine warm up.

    3. 0

      Tow bar

    4. 3

      Disconnecting winch, lightbar and UHF

    5. 0

      2011 Land Cruiser 1VD-FTV Engine Won't Start After Overhaul

    6. 3

      Disconnecting winch, lightbar and UHF

    7. 3

      Disconnecting winch, lightbar and UHF

    8. 3

      Disconnecting winch, lightbar and UHF

    9. 1

      Snapping wheel and axle studs

    10. 0

      2zz idle / roughness when accelerating past 3k

×
×
  • Create New...

Forums


News


Membership