-
Latest Postings
-
29
Where is the remote receiver on a 1998 Camry
Hi Martin, What exactly does or doesn't your remote do? If you can unlock and get into the car, but it doesn't start, that could be that RFID chip. We had that happen once, after I replaced the worn out case, with the silicon buttons with a new case. I didn't realise about that chip. Herb -
3
Getting a 99 CSX Camry into remote programming mode
Hey mate, how did you end up with this? Any success? Cheers. -
29
Where is the remote receiver on a 1998 Camry
Hi Herb, thanks for reply. I reckon this shouldn't be the case. Upper image is a original fob for Camry and if battery gone dead the only option is to go to dealer and buy a new fob for 100$. And you can also pair multiple (up to 4 fobs) to a car. The fob from Corolla (lower image) you can open and change batteries easily. As I mentioned in previous comment, it was recongised by the car (in a strange way) but finally does not work. It looks like to me that Integration Relay is OK since it recognsied the Corolla fob and the issue will be the original fob. Probably the button is gone or I don't know what else in the circuit board. Will try to measure it today if it is sending the signal. -
29
Where is the remote receiver on a 1998 Camry
Hi, I don't know if Toyota does this, but other makes have little RFID chip in the fob, separate to the electronics, which somehow validates the fob. Using a fob from a different car, even if the same model, may not work, because of this. Herb -
29
Where is the remote receiver on a 1998 Camry
Hi legends, I recently bought Camry 1999, and I'm trying to repair everything I can. Car came with one fob (famous unbreakable thingy, with button cover gone and flat battery of course). I have managed it to open and I choose the way to put the battery out of the pins - done, without breaking it. I bought CR2032 and put it into a place. Nothing, nothing happens while programming mode activated. Battery is in contact and button seems to be working fine (you can hear clicking). Then I simply gave up and tried to looking for new Integration Relay... one day I met bloke explaining him what am I after and he told me he has 1 fob at home but its from Corolla. OK let's give it a try. I set car into programming mode and after the procedure 3x on/off, etc... I got flashers slowly blinking but only 2 times. I started to getting happy 🙂 but at the end Corolla fob does not work at all, but at least I got some response from car... Any ideas? I want to avoid buying a new fob for 100$... Cheers! Martin -
0
1987 Toyota Corolla - 60 000km on the clock
Hi All I have a 1987 Corolla with 60 thousand kms on the clock. Immaculate condition on the inside, starts first go and all original. Looking to sell. What would this be worth? Thanks -
3
Toyota estima raised suspension
I love to know if he find the solution to raise his estima too. I can only manage to raise the rear of my 2008 estima with airbag installed, the front still low though. -
3
Toyota Landcruiser problems
Ah yes . Oh what a reaming..... Toyota.!! I had an aftermarket electric tailgate opener fitted $1500. Closes the door from inside and out. Mines a vx. Reverse sensors only turn off with toggle with "car and witches hat" on 300. They stay off till switched back on. I put my keys in the door pocket.the jingling almost drowns out the squeaking of the middle seats I sent a hand written registered letter personally addressed to the CEO of Toyota Australia and he did not have the decency to reply. Emails go ignored Toyota Lack of Customer Experience centre inept and uneducated regarding the legislation they are required to operate under. At least the 300 here didn't have the 3.5 TT petrol. Are you listening Toyota.??? NEVER AGAIN -
1
200 series after market 35 inch tyres
Ive seen a 200 with them fitted on the weekend and they were on 17s (GXL). The owner was very sheepish to say the least to pass on the info what had to be done other than some panel work on the from inner guards. 0 offset (bead lockers) and 3 inch lift and he still had rubbing. He was going to do some more panel work to allow the rubbing to not tear up inner guard (alloy plate) but it made my 200 with 20's and 2 inch lift look like a baby sitting next to it... -
13
300 series turbo issues
Hope I haven't posted twice but the issue is that this happens at all and the drop in torque and AFR off the chart when it does (7th injector problem??). By the time you notice it you're in a torque hole and your DPF is starting to cough coping with the lousy mixture. Nothing to do but push more fuel in and accelerate aou of it. It happens regardless of whether you notice it or not and regardless of whether you're towing. can't be doing the DPF any good. They're $7 grand to replace. They're still selling them and not telling anybody that this "design characteristic" is what to expect from your perfectly designed engine. Hopefully dyno report is attached. Ask what your service manager thinks and watch them squirm
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.