Robf

Hi Coleb161, Yes, I used the Ultra Racing bars Cheers Rob

Should fit OK, I have an Aurion Touring fitted with them. Made a big difference to the handling.

Has anyone purchased the Eonon D5116? If so how does it perform? Will it work with the factory fitted reverse camera? Cheers Rob

I will be interested to hear what difference this makes. I used dynamat on my wheel arches without any noticeable improvement in noise levels. The tyre noise on course bitumen is the one thing that I do not like about the Aurion.

Hi Toyota Pride, Did you stick it to the rear of the plastic or in the metal wheel well itself? Cheers Rob

Hi Julian, I had all sorts of trouble getting mine on trying to jack the car up, release the exhaust etc. If you have ramps that are at least 10" high then it will come out without any problems without having to undo anything else but the mounting nuts and bolts. If the car isn't high enough you can't twist the bar far enough to manouver it in (and the old one out). Cheers Rob

Finally got the rear sway bar fitted after being away for a few weeks. It is almost impossible to jack the car up high enough to get enough clearance to manipulate the sway bar out. On car ramps approx 10" inches high it becomes very easy to get it out and the new one in. Takes about 20 minutes all up Cheers Rob

About 10 days for mine

Car was level. Can't slide it towards the rear as the jacking point is in the way. Can't slide it forward as there is not enough clearance between the exhaust and pan. Looking at this pic which way would you suggest sliding to get it out?

Hi Silver Aurion, Thanks for the reply. No problem getting all the bolts out, only took a few minutes. Which way do you slide it to get it out!! It seems tucked in between the jacking point in the centre of the body and the floor pan

Fitted my Ultra racing Strut bar thus week and makes a huge difference to the way the car points into corners. I also got the 19mm rear sway bar but have not yet fitted. I have just tried to get the original sway bar off and have had no success manouvering it out. I don't have a hoist and was only able to jack the rear up to get the wheels slightly off the ground and put it on blocks. I removed both rear wheels but cannot work out a way of getting it around the exhaust, I can't drop the exhaust easily as I have a Hayman-Reece towbar which makes it impossible to drop the rear muffler brackets. Any suggestions on how to manouver it out would be greatly appreciated. Cheers Rob

I have just purchased an Aurion Touring, it has 2000km's on the clock so far and am experiencing a similar feel with the suspension. While it is quite firm over bumps it seems bouncy/spongy on a lot of roads. When I say bouncy it feels like sitting in a small boat with a slight swell. My daughter suffers from motion sickness and has noticed in the car that she feels squeemish when the bouncing occurs. My previous vehicle was a Commodore Berlina and the ride was not at all like this on the same roads. Any suggestions as to what could be causing this and suggestions on how to mimimise it would be good. I am looking at fitting the UR front strut brace and rear anti-roll bar, I am not sure if this could possibly improve the bouncyness at all. Cheers Rob