Coilovers

[Long T]

I just got a set of BC coilovers, BC-C-02-BR.

Never thought doing the height was so lengthy, mate showed me. Would like more help.

For the rears, there is a stud which i think shouldn't be there cause there is a bold that is weled to the body. Should I take it to peddars for it to be pressed out (the stud)?

I want to finish this ASAP.

Please help where ever

[123R-Prozak]

What? You talking about getting stock springs out? Suspension shouldn't be welded like that.. There a nut on the other side of it ?

[jeffy]

let me know if your fronts fit, because mine didnt fit ...

and for the rears, yes you need a spring compressor for it, take it to pedderps,

[SuperDave]

The zze corolla requires 2 nuts and 1 bolt at the rear for fitment, while the zzt celica requires 3 nuts. The mounting pattern is exactly the same, just the length varies by about 1-2" from memory. I have a thread in the suspension section comparing the two.

[Long T]

The front fit in nicely. For the rears, I wasnt sure what to do with 2 rings I had, i'm assuming they are for the celica

[SuperDave]

What do you mean by two rings? Got pictures?

[david.]

Is this for a zze corolla? If it is, I think those 2 'rings' you were talking about are washers that go between the strut and the other thingo when you bolt the bottom together.

If it isn't then ignore my post I'm useless to you :)

[ImPulse]

Hey man did you end up installing these?

I had the same problem, you just need a big hammer to knock that extra stud out of the BC upper mounting plate. It all lines up after that :)

Alfred