New Members Introductions
Are you a new member? Say hello here, let us know what you're driving and where you're from.
All new members are very welcome!
Notice
This area is for new members to introduce themselves. Please DO NOT post car related topics. All car related topics will be removed.
3,516 topics in this forum
-
- 1 reply
- 887 views
-
- 1 reply
- 1k views
-
- 1 reply
- 1.1k views
-
- 0 replies
- 866 views
-
- 0 replies
- 1.2k views
-
- 1 reply
- 1.1k views
-
- 1 reply
- 1k views
-
- 0 replies
- 887 views
-
- 1 reply
- 1.2k views
-
- 1 reply
- 1.1k views
-
-
- 0 replies
- 946 views
-
- 12 replies
- 2.2k views
-
- 14 replies
- 2.6k views
-
- 15 replies
- 3.1k views
-
- 8 replies
- 1.7k views
-
- 7 replies
- 1.8k views
-
Posts
-
-
Generally, yes. In the 60s, and earlier, there were cars with positive grounds, so I'm always a bit hesitant to say the negative wire. It is always the one that bolts to the body. Herb -
Hi everyone, I have a 2011 Land Cruiser VDJ200 with a 1VD-FTV engine. I recently had the engine fully overhauled due to a blown head gasket. However, after the overhaul, the engine is not starting. It only cranks but doesn't fire. I've checked the following DTC codes: Internal memory EEPROM error Low rail pressure The actual rail pressure data shows: 240 bar during cranking 61 bar when ignition is off Based on these findings, I suspect the following potential causes: =Defective Diesel High-Pressure Pump =Leaking Piezoelectric Injectors =Diesel Fuel Bypassing to the DPF Circuit =Faulty Injector Drivers I'm hoping for some expert advice to help diagnose and resolve this problem I'm seeking expert advice on how to troubleshoot and resolve this issue. Any suggestions or guidance would be greatly appreciated. -
By citrus__grove · Posted
Okay this might be dumb but it the ground the negative? -
Disconnecting batteries, ALWAYS disconnect the ground wire first. Doing this will also disconnect power, in general. Herb
-
-
Topics
-
-
