Jump to content

Recommended Posts

Posted

So I have started to face this issue of sluggish/slow acceleration with my 2ZZ-GE AE80, I changed the fuel pump, spark plugs, cleaned lift solenoid but same issue persisted. I went from 97RON to 92RON fuel for some reason and all of a sudden the car does not hesitate during acceleration, what can be the problem. Car used to have popping sound from exhaust before there was this issue.

Note: Water temp goes to 101ish and 2zz knocks due to 92RON while it never knocks or temperature never goes above 100C on 97 RON.

  • 4 weeks later...
Posted (edited)

Did you sort this problem? I'm having the same issues with my 01 V6 Camry. ECU threw code for a Coil. Replaced that, starts / idles better but still very sluggish and pops in Exhaust. Am thinking bad Cat and or Exhaust Oxy Sensor. (At night front of exhaust glows red). Opinions? Suggestions? (Have also just done Plugs and Leads as they were due).

Edited by Trikes
Posted
On 10/10/2019 at 2:39 AM, Raja Talha said:

So I have started to face this issue of sluggish/slow acceleration with my 2ZZ-GE AE80, I changed the fuel pump, spark plugs, cleaned lift solenoid but same issue persisted. I went from 97RON to 92RON fuel for some reason and all of a sudden the car does not hesitate during acceleration, what can be the problem. Car used to have popping sound from exhaust before there was this issue.

Note: Water temp goes to 101ish and 2zz knocks due to 92RON while it never knocks or temperature never goes above 100C on 97 RON.

Do you have any modifications done to the engine? I've seen issues caused by exhausts and intakes that are too large for the setup and actually decrease the overall performance all round.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Join The Club

    Join the Toyota Owners Club and be part of the Community. It's FREE!

  • Latest Postings

    1. 18

      High idling on the 2zzge even when warm (solved!)

    2. 5

      High RPM Idle after the engine warm up.

    3. 0

      Tow bar

    4. 3

      Disconnecting winch, lightbar and UHF

    5. 0

      2011 Land Cruiser 1VD-FTV Engine Won't Start After Overhaul

    6. 3

      Disconnecting winch, lightbar and UHF

    7. 3

      Disconnecting winch, lightbar and UHF

    8. 3

      Disconnecting winch, lightbar and UHF

    9. 1

      Snapping wheel and axle studs

    10. 0

      2zz idle / roughness when accelerating past 3k

×
×
  • Create New...

Forums


News


Membership