Ahhh Thomas you found some? :D I would suspect the normal way, remove the interior trim from the inside of the hatch, i think you have to start from the top of the window and work your way down the sides. From Minkara: (japlish) 手順としては、ウインドウの上→ウインドウの両サイド→ドアパネルの順番で外します。 As a procedure, remove the door panel in the order of → → windows on either side of the window. ウインドウの上はガラス側から手を突っ込み、手前引くと取れます。 Thrust his hand on the side window glass, pulled 取Remasu front. ただ、この時かなり力が必要ですのでケガには気をつけてください。 However, the injury must have considerable power, so please be careful at this time. 両サイドは、トノカバーの紐がかかっているフックのところを引っ張ってピンを抜くと取れます。 Both sides, pull out the pin 取Remasu just pulling the rope is at stake Tonokaba hook. ドアパネルは、最初にハッチのフック左側にあるクリップを外し、中央のピンを押し込んで、ドライバー等で外側のピンを引き抜き、ハッチの取っ手をはずしたら、両サイドの外した所から外します。 Door panel, remove the clip on the left side of the hatch to the first hook, push the center pin, pull the pin on the outside with a screwdriver, the handle of the hatch Hazu****ara away from the office off of both sides. 内張り外しは、基本的に力が要る作業ですが、あまり力ずくでやると、内張りのツメを折ったりするので注意してください Remove the lining, but I need the work force is basically to do so by force, please note that you can bend the tab on the ceiling If Johns sees this he will be bale to post up the other Minkara page i know of that has the full pics of the wiper delete job. Its prety much the same. Once the trim is off i suspect there will be a few 10mm nuts to remove then it should just pull out from the rear...