Landcruiser Club
750 topics in this forum
-
- 4 replies
- 4.4k views
-
- 5 replies
- 3.9k views
-
- 4 replies
- 2.1k views
-
- 0 replies
- 1.4k views
-
- 0 replies
- 1.3k views
-
- 1 reply
- 1.4k views
-
- 2 replies
- 2.1k views
-
- 1 reply
- 1.9k views
-
- 5 replies
- 2.1k views
-
- 1 reply
- 2.1k views
-
-
- 0 replies
- 1.1k views
-
- 0 replies
- 986 views
-
- 6 replies
- 7.4k views
-
- 1 reply
- 924 views
-
- 1 reply
- 1.8k views
-
- 4 replies
- 3.2k views
-
- 1 reply
- 1.4k views
-
- 0 replies
- 1.4k views
-
- 0 replies
- 805 views
-
- 0 replies
- 1.3k views
-
- 0 replies
- 657 views
-
- 1 reply
- 2.7k views
-
- 2 replies
- 4.6k views
-
- 3 replies
- 2.8k views
-
- 2 replies
- 1.7k views
-
Posts
-
By toyota 700 · Posted
Your starting problem could be engine timing .I had a no start problem and found that the engine had been apart and timed wrongly as there are2 marks on the internal gears so be carefull. Oil filters that will fit U10 are R2206P old ones but still available. Brake parts from local suppliers no problem and note that early UP10 had factory problems with the fuel pump not giving up enough fuel when engine under load. -
Hi team, I have ran into the same issue. Can I confirm where I should be placing these files within the SD folders? I can see a few .DAT format files however the name of the files doesn't exactly match what is currently on there. (e.g. this google drive folder contains EB, RG, SS & MM where as the folder on my SD has DAT files named ascbin, dtv_area, EMAP, MAPINFO... any ideas? Please note this is a 2010 Toyota Prius Synergy, industry model code DAA-ZVW30. Any help you can offer would be amazing! EDIT: I'm based in New Zealand if this affects filenames etc, which I assume it likely will. -
Hi Tony, You will need to make your own harness, with wire and corrugated tubing, you can buy at any auto shop. If there isn't a published wiring diagram, with colours, then I suggest you work out a colour scheme, so when you have the end of your harness you know which wire is which. As to the clutch switch, I've fitted a standard micro switch, on a home made bracket. The switch is wired in the normally open connection, as it is operated when the clutch is up. Note, the attached article is for my MGB brake switch replacement, but it will give you an idea about how to go about it. As to connecting to the ECU, if you do need to do it you only need to connect to the speed wire. If you have a tacho, then you could tap into the sense wire to it, using a quick splice connector, as shown, below. They are closed with a pair of pliers. Note that they come in different sizes, depending on the wire size. Herb Saga19 Brake switch.pdf -
-
-
-
Topics
-
-
