Jump to content

Are any of you on the list ?????

xoom
 Share

Recommended Posts

xoom Grand Master

xoom

Posted
Posted

I didnt even thing a site like this existed ..... i wonder what the legal ramification are ?????

Anyway just register .... its free .... and it will let u search for number plates by state .... I checked and im not on there .... are any of u ??????

http://www.idiotdriver.com.au


Danthuyer Grand Master

Danthuyer

Posted
Posted

i can see ALOT of false claims being made on this site which if these details were used could flame unwarrented and innocent people being made out to be something they are not


"RuNx" Grand Master

"RuNx"

Posted
Posted

thats funny!!!!!!!!!!!!! Damn i thought i would have been on it!!!!!LOL hey bill i bet VOY is on it though!!!!!

Azza Grand Master

Azza

Posted
Posted

Nothing on me yet

MT Grand Master

MT

Posted
Posted

they are also the smallest state.....

shhh... also the worst drivers according to something i read once.

CORZZA Grand Master

CORZZA

Posted
Posted

Non for me and i agree with Danthuyer

CORZZA Grand Master

CORZZA

Posted
Posted

I just reported myself :D LOL

but not showing up at all

cos you need to have a few people report you i think!

CORZZA Grand Master

CORZZA

Posted
Posted

iNteresting site...

not up there as yet in my 2.5 yrs of driving haha.

i think you should be! :) only joking!

  • 2 weeks later...
Buddha Grand Master

Buddha

Posted
Posted (edited)

This is certainly an interesting website, but I have concerns that not all complaints are legit.

For example, a lot of people have reported other drivers for keeping in the right-hand lane, without clarifying the circumstances. Some people think that you should keep left on any multi-lane road, whereas the road rules specify that the rule only applies at speed limits over 80 kmh and/or if there are "Keep left unless overtaking" signs erected.

Its therefore possible that some drivers have copped a spray on this website, even though they were perfectly within their rights to do what they were doing.

My favourite so far is the guy at on the Bruce Hwy at Narangba (north of Brissie) who was peeling prawns and throwing the shells out the window while sitting on 100 kmh ... I'm flat out peeling one of the little buggers standing still! :P

EDIT: Just found an example of what I'm talking about ... theres a post on the site having a go at a guy who was sitting in the right hand lane and then turned suddenly into a servo ... fair enough about the sudden turn, but this was on Wynnum Rd at Tinglpa (southside of Brissie) where the speed limit doesn't exceed 80, nor are there any keep left signs, so he was perfectly within his rights to sit in the right hand lane.

Edited by Buddha
"RuNx" Grand Master

"RuNx"

Posted
Posted

Why is my name brought up Jin Diesel.

Even if it is, it was you who probably put it on there.... :angry::lol:

Man believe me im trying to put you on it!!!You deserve to be there as the most notorious in NSW (sydney area)LOL :lol::lol: :P

"RuNx" Grand Master

"RuNx"

Posted
Posted

Actually Dylan u are on it!!!!!LOL Some-thing about the nasho!!!!LOL.....Just jokes!!!!!! If that was the case it waould be all of US!!!!! ^_^ ^_^ :D :lol:

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing



  • Join The Club

    Join the Toyota Owners Club and be part of the Community. It's FREE!

  • Latest Postings

    1. 18

      High idling on the 2zzge even when warm (solved!)

      i am in sydney, just got 1992 tarago, same problem, 2k idle speed when engine warm, changed the whole throttle body, ECU, still same, help pls in sydney 0405987988
      moxabest in Corolla / Corolla Sportivo Club
    2. 5

      High RPM Idle after the engine warm up.

      i have same problem, already changed throttle body, ecm modle, help pls
      moxabest in Inside and Out
    3. 0

      Tow bar

      Hi guys, Just bought my new Landcruiser Prado yesterday. What is the difference between Onroad Towner and Off road Towbar
      Kiru in Prado Club
    4. 3

      Disconnecting winch, lightbar and UHF

      Generally, yes. In the 60s, and earlier, there were cars with positive grounds, so I'm always a bit hesitant to say the negative wire. It is always the one that bolts to the body. Herb
      ozieagle in Landcruiser Club
    5. 0

      2011 Land Cruiser 1VD-FTV Engine Won't Start After Overhaul

      Hi everyone, I have a 2011 Land Cruiser VDJ200 with a 1VD-FTV engine. I recently had the engine fully overhauled due to a blown head gasket. However, after the overhaul, the engine is not starting. It only cranks but doesn't fire. I've checked the following DTC codes: Internal memory EEPROM error Low rail pressure The actual rail pressure data shows: 240 bar during cranking 61 bar when ignition is off Based on these findings, I suspect the following potential causes: =Defective Diesel High-Pressure Pump =Leaking Piezoelectric Injectors =Diesel Fuel Bypassing to the DPF Circuit =Faulty Injector Drivers I'm hoping for some expert advice to help diagnose and resolve this problem I'm seeking expert advice on how to troubleshoot and resolve this issue. Any suggestions or guidance would be greatly appreciated.
      kevin200 in Landcruiser Club
    6. 3

      Disconnecting winch, lightbar and UHF

      Okay this might be dumb but it the ground the negative?
      citrus__grove in Landcruiser Club
    7. 3

      Disconnecting winch, lightbar and UHF

      Disconnecting batteries, ALWAYS disconnect the ground wire first. Doing this will also disconnect power, in general. Herb
      ozieagle in Landcruiser Club
    8. 3

      Disconnecting winch, lightbar and UHF

      Hey guys, I’m wanting to disconnect my current winch, lightbar and UHF as I have new plans. I’ve installed a winch previously on another car so I get it’s a case of following the cables and disconnecting from the battery, etc but but safety wise, should I start by disconnecting the battery so the cables aren’t live orrrr? And if so how do it go this haha?
      citrus__grove in Landcruiser Club
    9. 1

      Snapping wheel and axle studs

      Put a set of standard wheels on it and your problem will disappear. It is critical that the hole in the wheel centre is a snug fit on the axle boss (without wheel nuts fitted). If your wheels are sloppy on the axle boss this allows excess force on your wheel studs and they will break, as yours are doing. If you are unsure of what to do, go to a reputable tyre shop and get assistance.
      32V8 in Landcruiser Club
    10. 0

      2zz idle / roughness when accelerating past 3k

      Hey everyone was hoping someone might be able to point me in the right direction with this issue I've been facing for a while now. My Celica's idle will drop down to almost 200rpm when stationery after hitting operating temperature. Pretty much feels like it's about to stall out but never actually does. When taking off from a set of lights it almost feels like it hesitates or is down on power and then all of a sudden it lurches forward and gets a boost in power again. Then again around 1,500-3,000rpm it feels down on power and in what I can only describe in the engine feeling scratchy. Past 3,000 rpm it gets a little boost in power again but still definitely feels down on power compared to what it used to be and still has that roughness. Note lift is also not working at the moment but I have changed the lift bolts, planning on cleaning the VVT and VVTL-i OCV's New engine mounts have been installed I changed the MAF sensor about 4 years ago albeit not OEM. After doing some research my main ideas now would be a New MAF this time OEM, TPS, IACV or Coil Packs (Changed plugs 50,000km ago) Any other suggestions would be greatly appreciated!!! :)
      ik04 in Celica Club
×
×
  • Create New...

Forums

News

Membership