bc br coilovers

[ptagna]

hey guys i just ordered a set of bc br coilovers from justjap .

my question is anyone have a height recommendations i should have ( i want low but not alot of scraping everywhere i go lol)

also where should i take it to get them put on (cost wise and advice ) in west side melbourne.

cheers guys

[jeffy]

1 FINGER GAPP ! :D

[123R-Prozak]

Lol yeh 1 finger

Scraping? Load up your back seat and check the height then

[4ABHGE]

Cheapest: DIY, then get someone to do a wheel alignment for you.

[Kenshin X]

pedders south melbourne. they've always looked after me. but yeah DIY and get them to do wheel alllignment if u can :P

the height? well i like an even gap between the wheel arch and the tyre. these coils won't let me do that though. though thats with weight on the back. if i take out all the weight i possible could the gap will be even again :) perfect for the conditions i put my car through :P

[Trickey]

Just sack it ^___^ i'd just put it sitting just above the tire.

[clifton]

you need tuck at the rear!

[Kenshin X]

LAWL CLIFTON

btw i like ur style

i would put it that low, if it wasnt not so practical and our roads weren't as sh#tty.

[GHOSTIVO]

low enough so your exhaust can make sparks.

[Kenshin X]

low enough so your exhaust can make sparks.

fully sik bruuu

[GHOSTIVO]

low enough so your exhaust can make sparks.

fully sik bruuu

spark makes your car go quicker

[ImPulse]

1 finger! hahah that's what i'm set on :) just take speedbumps at angles

[dyslexik]

LAWL CLIFTON

btw i like ur style

i would put it that low, if it wasnt not so practical and our roads weren't as sh#tty.

Yeh that low in Melb and u can kiss goodbye to your exhaust system over the half size cement speed humps. i.e. Nicholson St, Richmond.

[ptagna]

Got my coilovers installed :) can fit my fingers into the gap but back is higher than the front lol. anywho ever since then i drove it for one day no noise has occured. the next day sometimes when i turn the wheel it makes like a rubbing noise first i thought the front was too low but it didnt look from the front it wasnt rubbing anything. anyone able to help me figure this problem out lol . also my front right cv boot is leaking if it helps also i havent got a wheel alignment yet

cheers

Edited April 10, 2012 by ptagna

[clifton]

Does it make the noise when you're full lock or close to it?

[ptagna]

Does it make the noise when you're full lock or close to it?

just whenever i turn it sometimes. even if its just like a little bit :/

Edited April 11, 2012 by ptagna

[jeffy]

wheels too phat ?