Jump to content


Aurion TRD Full custom exhaust system

MDPTRD

By MDPTRD
in Aurion / TRD Aurion Club

 Share

Recommended Posts

MDPTRD Progessing

MDPTRD

Posted
Posted (edited)

Hi Everyone!

My centre catalytic converter had somehow sh*t itself and the aurion is now coming up with a warning light due to a bad reading, this was confirmed by a Toyota dealer and the cat needed replacing.

Instead, Im considering a full custom exhaust system from the extractors including high flow cat converter and two Magnaflow mufflers.

Was wondering if anyone has done this before or something similar to their TRD? If a full system will mess with the catalytic sensors and the warning light still remains.

I've been quoted about $3.3k for a full stainless custom system and dont know if it would be recommended technically, other then looks and sounds.

Was wondering if there would be a significant performance gain or potential lost...

Your advice will be much appreciated.

Mark

Edited by MDPTRD
trentmeyer23 Grand Master

trentmeyer23

Posted
Posted

Thats a hell expensive exhaust...are the extractors custom made too?

MDPTRD Progessing

MDPTRD

Posted
  • Author
Posted

Yes, there custom made and stainless. I don't think there is a bolt on / aftermarket available for aurions / TRDs.

DJKOR Grand Master

DJKOR

Posted
Posted

Yes, there custom made and stainless. I don't think there is a bolt on / aftermarket available for aurions / TRDs.

Actually there is, but it still requires some custom pipework afterwards:

http://www.monkeywrenchracing.com/product_info.php?cPath=318&products_id=1192

Personally, I beleive the gains to be made will be with the re-making of the y-pipe where the exhaust manifold from each cylinder bank merges.


Andrew357 Grand Master

Andrew357

Posted
Posted

Yes, there custom made and stainless. I don't think there is a bolt on / aftermarket available for aurions / TRDs.

Actually there is, but it still requires some custom pipework afterwards:

http://www.monkeywrenchracing.com/product_info.php?cPath=318&products_id=1192

Personally, I beleive the gains to be made will be with the re-making of the y-pipe where the exhaust manifold from each cylinder bank merges.

Is the TRD Aurion y-pipe the same as the one on the regular Aurion? If so, you're probably right as the y-pipe is terrible.

450HP/tonne Mentor

450HP/tonne

Posted
Posted

Is the TRD Aurion y-pipe the same as the one on the regular Aurion?

Exactly the same part for both models.

MDPTRD Progessing

MDPTRD

Posted
  • Author
Posted (edited)

Thanks Djkor,

So these extractors are a definite bolt on for the TRD? If that's the case then it would save me a fortune and the remaining custom piping shouldn't be too much.

Edited by MDPTRD
Andrew357 Grand Master

Andrew357

Posted
Posted

Thanks Andrew,

So these extractors are a definite bolt on for the TRD? If that's the case then it would save me a fortune and the remaining custom piping shouldn't be too much.

Don't thank me, DJKOR posted the link and according to what he is saying; you will need to do a little work afterwards. I can just say, if the 2gr is anything like the 1mz it will react well to the y-pipe modification. The 1mz has a crappy y-pipe that rivals the 2gr.

I can't tell you what kind of gains you'll get from these collectors however.

Thats a hell expensive exhaust...are the extractors custom made too?

Not that expensive Trent. My CES setup in mild steel was $3000 and that does not include a hi-flow cat!

DJKOR Grand Master

DJKOR

Posted
Posted

So these extractors are a definite bolt on for the TRD? If that's the case then it would save me a fortune and the remaining custom piping shouldn't be too much.

They are a definite bolt on for a standard Aurion when used in conjunction with a cutom exhaust from that point onwards. In case you haven't looked, the TRD is no different.

On the topic of cats, I wouldn't waste your money on a "high flow" cat for the Aurion/TRD... but hey, it's your money.

johnnieboi Grand Master

johnnieboi

Posted
Posted

Hope your ECU is nothing like the zre because all that extra flow may cause you to run lean with your A/F ratio and throw a CEL.

DJKOR Grand Master

DJKOR

Posted
Posted

Hope your ECU is nothing like the zre because all that extra flow may cause you to run lean with your A/F ratio and throw a CEL.

LOL. Lean...

Dyno_2.jpg

I think she has a bit of play before it will sense somthing wrong.

  • 2 weeks later...
SCOOTA44 Grand Master

SCOOTA44

Posted
Posted

saw the bolt-ons at monkey wrench they look great, but i noticed they eliminate the pre-cats, what happens to the sensors? as these read the gas mix after the pre-cats. also another thought, if you have to modify everything after the headers, why not 2 main cats and twin all the way, i have seen some very small stainless high flow cats which would fit side by side. the headers would make it easier to make the rear bank pipe longer for "equal length" system.

  • 4 months later...
MDPTRD Progessing

MDPTRD

Posted
  • Author
Posted

Hi Everyone.

Sorry to revive an old thread...

Im hoping some experts out there may be able to clarify something for me. I own an Aurion TRD and the engine light came on, had the code read and it confirmed it was the cat converter. I wasn't able to confirm whether it was the bottom or top cat. I took a guess and assumed it was the bottom cat and went out and fitted a high flow cat, 2.75 piping, and 2 magnaflow exhausts. (love the sound) Unfortunately, this did not make the error light go away so again, I went back to toyota and was advised I would need my top cat replaced along with the manifold. Toyota quoted 1.5k which is a really big bite out of my pocket and im trying to cut cost to have this problem fixed.

Can someone please confirm if the other aurion vs the TRD aurion have exactly the same manifold and top cat? I would prefer to find a 2nd hand alternative and cut cost. It would be great news if they are the same since TRDs are hard to come by as it is and to find a genuine 2nd TRD part will be near impossible.

Thanks very much in advance!

Regards,

Mark

Steven Grand Master

Steven

Posted
Posted

The exhaust manifolds are exactly the same, and can be found at wreckers however due to the included cat they sometimes ask a fair bit for them. Still far cheaper than genuine though

450HP/tonne Mentor

450HP/tonne

Posted
Posted

I wasn't able to confirm whether it was the bottom or top cat. I took a guess and assumed it was the bottom cat

I'm not surprised the lamp was still on, as there are no sensors after the bottom cat:

3460d527.jpg

The sensors are measuring the performance of the manifold cats, which is where your problem will be 99.7% of the time.

Do you know which code was found? The code will tell you which bank has the problem, so the repair cost could be halved if you know (compared with trial and error methods). The quoted price sounds like only 1 manifold, so try and find out which one ...

MDPTRD Progessing

MDPTRD

Posted
  • Author
Posted

Hi Steven,

Thanks for your clarification, im relieved to hear that!

Hi 450,

Appreciate your response. This is what toyota advised on the job sheet "error code P0430 catylst system efficiency below threshold, carried out live data check of O2 sensors, found operating within specified range, recommend replacement of cat converter"

Cheers

Mark

450HP/tonne Mentor

450HP/tonne

Posted
Posted

This is what toyota advised on the job sheet "error code P0430 catylst system efficiency below threshold, carried out live data check of O2 sensors, found operating within specified range, recommend replacement of cat converter"

The problem is with bank 2 (front).

Could be one of the problems below, but maybe the dealer has eliminated the sensors and gas leak:

18a96fdf.jpg

See if you can get a front cat ...

Pah Grand Master

Pah

Posted
Posted

LOL. How convenient.

LOL thats what I thought I just finished reading the forum and decided to check Ebay to see what new listings there were for Aurion and they were there :clap:

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing



  • Join The Club

    Join the Toyota Owners Club and be part of the Community. It's FREE!

  • Latest Postings

    1. 0

      E160 Corolla fielder suspension

      Does any one know if the trd sportivo suspension for the 2017 facelift corolla fielder fits the 2013 prefacelift version? Is the chassis the same? Thanks for the help.
      jay886 in Corolla / Corolla Sportivo Club
    2. 0

      Remote start

      What bipass do i need for immobilliser to install a remote start to my 2021 hiace
      chris mc1 in Audio/Video/Electronics
    3. 1

      1999 Camry Driver's door locking hatch issue

      It's possible that it could be something fouling or dirt build up, dry, or a broken mechanism, so have a look and give the mechanism some lubrication, most likely though, it'll be the actuator. I found one for a good price on Ebay, $25 delivered: Front Door Lock Actuator Right Side For Toyota Camry 1997-2001 | eBay
      Monad in Camry Club
    4. 0

      Query about the correct rotors for 2006 ACV40 Camry.

      Hi, I'm looking at a set of front rotors for an ACV40 2006, 2.4L Camry. I got a good price on some RDA's at Sparesbox. However both RDA8112 and RDA7686 show as for my car and I'm wondering what the difference is and if there were changes to the rotors during the model production. So does anyone know which rotor is the correct one? Many thanks in advance.
      Monad in Camry Club
    5. 9

      Android auto

      It's a simple solution though? Already laying down 60k for a RAV4, so what's another 1k on a phone to make everything work seamlessly? 👍
      L4WL3SS in RAV4 Club
    6. 9

      Android auto

      Your solution is akin to suggesting that switching to a different car manufacturer would resolve the issue. However, not everyone shares the same enthusiasm for using an iPhone as you do.
      Equi28 in RAV4 Club
    7. 1

      Turboed Corolla Overbuilt?

      that engine will be fine, the rods are the main thing to be concerned about. The 2860 is a decent turbo for the 1zz but in this day and age I'd go for a G25-550. The injectors might be on the small side, we run DW1000's. You need a full length injector, the shorter injectors with adaptors like ID1050x dont fit the 1zz head. You don't need an aftermarket intake manifold, if you do go down that path, avoid the CNC innovations unit, it's garbage. Do the boost control with a MAC valve and control it with the aftermarket ECU of your choice, I use Link stuff on most of my builds with the G4x Storm as the minimum. I also wire a fuel pressure sensor and oil pressure sensor to the ECU in my installs. Use a decent intercooler, the better cores (ARE, PWR, Garrett, Vibrant, Plazmaman, Hypertune) work a lot better than the chinese stuff like Aeroflow. a 450x250-300 fits fairly well with custom end tanks to route the cooler pipes through next to the radiator Don't forget about the clutch and gearbox. These days I like the Uniclutch twinplate, Above 300whp you'll want to think about upgrading the 3rd and 4th gears in the box also with the SSC (Hollinger) gear set and install an LSD of your choice. If you're going to give it a hard time, you'll also want an oil cooler. I like the HKS thermostat type sandwich plates and setrab or mocal oil coolers with -10 speedflow fittings/lines (Chinese AN fittings neck down to a lot smaller internal diameter in their bends, not great for flow) You'll also want to think about brakes, Celica or Sportivo front calipers will bolt on with sportivo discs as a starting point. To have somewhere like Tunehouse do the work you'll want to budget somewhere between 20-40K
      CHA54 in Corolla / Corolla Sportivo Club
    8. 3

      Camry Touring 2010 Fuel consumption 15.2L/100km. Normal?

      I did the mathematics myself regarding costs vs benefits for fuel injector cleaner. I have changed from 91ULP to 95PULP and 98PULP. Price difference can be about 13 -20 cents. Compared to 91ULP, Premium quality fuel should have a better quality additive package designed to have superior engine cleaning capabilities so the engine can perform at their best.
      campbeam in Camry Club
    9. 3

      Camry Touring 2010 Fuel consumption 15.2L/100km. Normal?

      "Fuel injector cleaner is a waste of money" Only if you by the cheap crap if you use LiquMolly a German Product it does work and you won't waste your Money.
      Aussie Camry in Camry Club
    10. 0

      Camry Touring 2010 A/C Issues.

      Hi Guys, My Camry 2010 Touring just had a regas done on it and the next day for some reason it wasn't blowing cold air but the next day it is and now working with nice cold air BUT every now and then we can hear and feel a buzz for a few secounds and today while my sister took my car I could her like a mild knocking sound when stopped but goes away when driving off. Any idea what this could be and the A/C is always working now for now.
      Aussie Camry in Camry Club
×
×
  • Create New...

Forums

News

Membership