Jump to content


Freakin Hawt!

apg39

By apg39
in Aurion / TRD Aurion Club

 Share

Recommended Posts

apg39 Veteran

apg39

Posted
Posted

These pics are of Joey888's ride from camryclub.com

Love the exhaust - if it didnt stick out so far I'd definitley want that one.

DSC_0247.jpg

DSC_0240.jpg

DSC_0243.jpg

DSC_0245.jpg

DSC_0253.jpg

akuma Grand Master

akuma

Posted
Posted (edited)

i love it

Edited by akuma
lateralus Grand Master

lateralus

Posted
Posted

in the second and third pictures, it looks a bit like an hsv senator. i think its just the way the light is reflecting above the wheel arches that makes them look highly flared

very nice though!

qkslvr Grand Master

qkslvr

Posted
Posted
i loled @ the badge

prettty smiick :)

It's in reference to the 'VIP' styling made popular in Japan. look it up, it usually involves pimp'd out lexus'.

VF-X Grand Master

VF-X

Posted
Posted (edited)
These pics are of Joey888's ride from camryclub.com

Love the exhaust - if it didnt stick out so far I'd definitley want that one.

Yea...Stick out too much and a bit too big IMO...

Im lookin for those kind too...

Looks Hott

Btw, the 'hole' thing above the front wheel looks good...Didnt realize it till just now..

Edited by VF-X
Pumped Proficient

Pumped

Posted
Posted
i loled @ the badge

prettty smiick :)

It's in reference to the 'VIP' styling made popular in Japan. look it up, it usually involves pimp'd out lexus'.

i know what its in reference to dude

i dont think he needed to point it out though

its like putting a badge on a car that says "JDM"

:P

spags Rising Star

spags

Posted
Posted (edited)

***** hot

I wonder if id be able to get a hold of that rear spoiler from somewhere. looks mad

and whats he done near the top of front wheel on the body??

Edited by spags
Lawz Grand Master

Lawz

Posted
Posted

that's just pure sex. I love it.

apg39 Veteran

apg39

Posted
  • Author
Posted
I wonder if id be able to get a hold of that rear spoiler from somewhere. looks mad

and whats he done near the top of front wheel on the body??

Its just the Camry ducktail spoiler seen on our Aus models, check out ebay cos there's lots there.

Looks like a fender vent as seen on Commodores.

  • 1 month later...
Steve Grand Master

Steve

Posted
Posted

i have just messed my pants, and its not the rear

that car is awesome!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing



  • Join The Club

    Join the Toyota Owners Club and be part of the Community. It's FREE!

  • Latest Postings

    1. 18

      High idling on the 2zzge even when warm (solved!)

      i am in sydney, just got 1992 tarago, same problem, 2k idle speed when engine warm, changed the whole throttle body, ECU, still same, help pls in sydney 0405987988
      moxabest in Corolla / Corolla Sportivo Club
    2. 5

      High RPM Idle after the engine warm up.

      i have same problem, already changed throttle body, ecm modle, help pls
      moxabest in Inside and Out
    3. 0

      Tow bar

      Hi guys, Just bought my new Landcruiser Prado yesterday. What is the difference between Onroad Towner and Off road Towbar
      Kiru in Prado Club
    4. 3

      Disconnecting winch, lightbar and UHF

      Generally, yes. In the 60s, and earlier, there were cars with positive grounds, so I'm always a bit hesitant to say the negative wire. It is always the one that bolts to the body. Herb
      ozieagle in Landcruiser Club
    5. 0

      2011 Land Cruiser 1VD-FTV Engine Won't Start After Overhaul

      Hi everyone, I have a 2011 Land Cruiser VDJ200 with a 1VD-FTV engine. I recently had the engine fully overhauled due to a blown head gasket. However, after the overhaul, the engine is not starting. It only cranks but doesn't fire. I've checked the following DTC codes: Internal memory EEPROM error Low rail pressure The actual rail pressure data shows: 240 bar during cranking 61 bar when ignition is off Based on these findings, I suspect the following potential causes: =Defective Diesel High-Pressure Pump =Leaking Piezoelectric Injectors =Diesel Fuel Bypassing to the DPF Circuit =Faulty Injector Drivers I'm hoping for some expert advice to help diagnose and resolve this problem I'm seeking expert advice on how to troubleshoot and resolve this issue. Any suggestions or guidance would be greatly appreciated.
      kevin200 in Landcruiser Club
    6. 3

      Disconnecting winch, lightbar and UHF

      Okay this might be dumb but it the ground the negative?
      citrus__grove in Landcruiser Club
    7. 3

      Disconnecting winch, lightbar and UHF

      Disconnecting batteries, ALWAYS disconnect the ground wire first. Doing this will also disconnect power, in general. Herb
      ozieagle in Landcruiser Club
    8. 3

      Disconnecting winch, lightbar and UHF

      Hey guys, I’m wanting to disconnect my current winch, lightbar and UHF as I have new plans. I’ve installed a winch previously on another car so I get it’s a case of following the cables and disconnecting from the battery, etc but but safety wise, should I start by disconnecting the battery so the cables aren’t live orrrr? And if so how do it go this haha?
      citrus__grove in Landcruiser Club
    9. 1

      Snapping wheel and axle studs

      Put a set of standard wheels on it and your problem will disappear. It is critical that the hole in the wheel centre is a snug fit on the axle boss (without wheel nuts fitted). If your wheels are sloppy on the axle boss this allows excess force on your wheel studs and they will break, as yours are doing. If you are unsure of what to do, go to a reputable tyre shop and get assistance.
      32V8 in Landcruiser Club
    10. 0

      2zz idle / roughness when accelerating past 3k

      Hey everyone was hoping someone might be able to point me in the right direction with this issue I've been facing for a while now. My Celica's idle will drop down to almost 200rpm when stationery after hitting operating temperature. Pretty much feels like it's about to stall out but never actually does. When taking off from a set of lights it almost feels like it hesitates or is down on power and then all of a sudden it lurches forward and gets a boost in power again. Then again around 1,500-3,000rpm it feels down on power and in what I can only describe in the engine feeling scratchy. Past 3,000 rpm it gets a little boost in power again but still definitely feels down on power compared to what it used to be and still has that roughness. Note lift is also not working at the moment but I have changed the lift bolts, planning on cleaning the VVT and VVTL-i OCV's New engine mounts have been installed I changed the MAF sensor about 4 years ago albeit not OEM. After doing some research my main ideas now would be a New MAF this time OEM, TPS, IACV or Coil Packs (Changed plugs 50,000km ago) Any other suggestions would be greatly appreciated!!! :)
      ik04 in Celica Club
×
×
  • Create New...

Forums

News

Membership