Jump to content


SPOTTED THREAD

Azza

By Azza
in Site Suggestions

 Share

Recommended Posts

Azza Grand Master

Azza

Posted
Posted

I really enjoy the spotted thread, because it helps us see whos out and about on the road.

What I was thinking was if we could move the one we have now into the 'General' section (where the lounge etc sits) and have a state by state break up as sub directories:

SPOTTED! -

=> QUEENSLAND

=> NSW

=> VICTORIA

=> SOUTH AUSTRALIA

You get the drift....

Just so we dont have to trawl through heaps of posts....


Northy Grand Master

Northy

Posted
Posted

sounds like a good idea, unless we get any good reasons why this should not happen ill knock somthing up today

SILVABULLIT Grand Master

SILVABULLIT

Posted
Posted

yeah do it mate cause it's pretty annoying with people saying that they saw someone on such and such a street but that member lives in Sydney not Brisbane cause both cities have a street of the same name.

MarkMish Grand Master

MarkMish

Posted
Posted

sounds good!!

there are a lot of suburbs and street names similar in all states..............its very confusing..........:D


Azza Grand Master

Azza

Posted
  • Author
Posted

sounds like a good idea, unless we get any good reasons why this should not happen ill knock somthing up today

Did you get a chance to look at this Corey?? Doesn't look like anybody has too many objections....

BigBum Grand Master

BigBum

Posted
Posted

I like the idea too :D

Lets get STATE SPECIFIC threads in the club meets & events section. Then all the meet photos can go into your State's thread, discussions, future events, etc, etc.

Azza Grand Master

Azza

Posted
  • Author
Posted

I like the idea too :D

Lets get STATE SPECIFIC threads in the club meets & events section. Then all the meet photos can go into your State's thread, discussions, future events, etc, etc.

Sounds good....

Azza Grand Master

Azza

Posted
  • Author
Posted

So, I know you've been sick Corey, but where's it at....

counc Advancing

counc

Posted
Posted

definatly a good idea here, most othere forum sites im with run it along these lines too. It just make things easier for all concerned

cheers

  • 2 weeks later...
Azza Grand Master

Azza

Posted
  • Author
Posted

Any progress ???????

MT Grand Master

MT

Posted
Posted

Azza i reckon just start them all off and i'll pin them and hide the old one. i'd say make 3, QLD one, VIC one and a NSW one...

otherwise it might not happen :P

Dead Grand Master

Dead

Posted
Posted

Canberra is ignored once again lmao

Backstreet Boys interview on the Chaser:

"Guys I have a question...what is the capital of Australia?"

"...................uh...is it..........uh.............adelaide? no? sydney? uh...melbourne? I uh..."

"No no, guys it's ok...I didn't think you'd get it either."

LMAO

MR22ZZ Grand Master

MR22ZZ

Posted
Posted

other includes SA, WA, NT and ACT... there are still less members from all of these places combined then are regulars for any one of the other states.

GReddy_ES Grand Master

GReddy_ES

Posted
Posted

other includes SA, WA, NT and ACT... there are still less members from all of these places combined then are regulars for any one of the other states.

uhuh..that makes sense..thanks for that :D

  • 3 months later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing



  • Join The Club

    Join the Toyota Owners Club and be part of the Community. It's FREE!

  • Latest Postings

    1. 18

      High idling on the 2zzge even when warm (solved!)

      i am in sydney, just got 1992 tarago, same problem, 2k idle speed when engine warm, changed the whole throttle body, ECU, still same, help pls in sydney 0405987988
      moxabest in Corolla / Corolla Sportivo Club
    2. 5

      High RPM Idle after the engine warm up.

      i have same problem, already changed throttle body, ecm modle, help pls
      moxabest in Inside and Out
    3. 0

      Tow bar

      Hi guys, Just bought my new Landcruiser Prado yesterday. What is the difference between Onroad Towner and Off road Towbar
      Kiru in Prado Club
    4. 3

      Disconnecting winch, lightbar and UHF

      Generally, yes. In the 60s, and earlier, there were cars with positive grounds, so I'm always a bit hesitant to say the negative wire. It is always the one that bolts to the body. Herb
      ozieagle in Landcruiser Club
    5. 0

      2011 Land Cruiser 1VD-FTV Engine Won't Start After Overhaul

      Hi everyone, I have a 2011 Land Cruiser VDJ200 with a 1VD-FTV engine. I recently had the engine fully overhauled due to a blown head gasket. However, after the overhaul, the engine is not starting. It only cranks but doesn't fire. I've checked the following DTC codes: Internal memory EEPROM error Low rail pressure The actual rail pressure data shows: 240 bar during cranking 61 bar when ignition is off Based on these findings, I suspect the following potential causes: =Defective Diesel High-Pressure Pump =Leaking Piezoelectric Injectors =Diesel Fuel Bypassing to the DPF Circuit =Faulty Injector Drivers I'm hoping for some expert advice to help diagnose and resolve this problem I'm seeking expert advice on how to troubleshoot and resolve this issue. Any suggestions or guidance would be greatly appreciated.
      kevin200 in Landcruiser Club
    6. 3

      Disconnecting winch, lightbar and UHF

      Okay this might be dumb but it the ground the negative?
      citrus__grove in Landcruiser Club
    7. 3

      Disconnecting winch, lightbar and UHF

      Disconnecting batteries, ALWAYS disconnect the ground wire first. Doing this will also disconnect power, in general. Herb
      ozieagle in Landcruiser Club
    8. 3

      Disconnecting winch, lightbar and UHF

      Hey guys, I’m wanting to disconnect my current winch, lightbar and UHF as I have new plans. I’ve installed a winch previously on another car so I get it’s a case of following the cables and disconnecting from the battery, etc but but safety wise, should I start by disconnecting the battery so the cables aren’t live orrrr? And if so how do it go this haha?
      citrus__grove in Landcruiser Club
    9. 1

      Snapping wheel and axle studs

      Put a set of standard wheels on it and your problem will disappear. It is critical that the hole in the wheel centre is a snug fit on the axle boss (without wheel nuts fitted). If your wheels are sloppy on the axle boss this allows excess force on your wheel studs and they will break, as yours are doing. If you are unsure of what to do, go to a reputable tyre shop and get assistance.
      32V8 in Landcruiser Club
    10. 0

      2zz idle / roughness when accelerating past 3k

      Hey everyone was hoping someone might be able to point me in the right direction with this issue I've been facing for a while now. My Celica's idle will drop down to almost 200rpm when stationery after hitting operating temperature. Pretty much feels like it's about to stall out but never actually does. When taking off from a set of lights it almost feels like it hesitates or is down on power and then all of a sudden it lurches forward and gets a boost in power again. Then again around 1,500-3,000rpm it feels down on power and in what I can only describe in the engine feeling scratchy. Past 3,000 rpm it gets a little boost in power again but still definitely feels down on power compared to what it used to be and still has that roughness. Note lift is also not working at the moment but I have changed the lift bolts, planning on cleaning the VVT and VVTL-i OCV's New engine mounts have been installed I changed the MAF sensor about 4 years ago albeit not OEM. After doing some research my main ideas now would be a New MAF this time OEM, TPS, IACV or Coil Packs (Changed plugs 50,000km ago) Any other suggestions would be greatly appreciated!!! :)
      ik04 in Celica Club
×
×
  • Create New...

Forums

News

Membership