Rav 4
528 topics in this forum
-
- 243 replies
- 56k views
-
- 1 reply
- 442 views
-
- 5 replies
- 777 views
-
- 2 replies
- 1k views
-
- 0 replies
- 549 views
-
- 9 replies
- 1.1k views
-
- 1 reply
- 630 views
-
- 1 reply
- 370 views
-
- 1 reply
- 429 views
-
- 2 replies
- 2.6k views
-
-
- 2 replies
- 2.2k views
-
- 3 replies
- 2.1k views
-
- 0 replies
- 650 views
-
- 1 reply
- 1.3k views
-
- 2 replies
- 1.2k views
-
- 1 reply
- 795 views
-
- 5 replies
- 10.8k views
-
- 4 replies
- 2.2k views
-
- 0 replies
- 693 views
-
- 0 replies
- 985 views
-
- 3 replies
- 2.6k views
-
- 0 replies
- 948 views
-
- 2 replies
- 847 views
-
- 0 replies
- 914 views
-
- 0 replies
- 1.1k views
-
Posts
-
By BIG BROWN SHARK · Posted
g'day, New here. Im looking for advice for KUN26 SR5. Replacing a canopy with a factory 3 piece hard and lid sports bar. Couple of issues im having is: It appears originally the tub liner would be trimmed? and a black bar (approx 50x50) is mounted to the front of the tub, where the hinges for the lid are riveted too. Rather than trim the liner, ive used an aluminium fencing rail which attached to the tub the overlal dimensions are the same and i have the lid sitting in place. All good there. However, i now have 2 issues. The sports bar mounting point at the front of the tub, is 2x20mm holes wihtout a thread. The mounting holes a little further back have an m8 thread. I reckon theres a plate with nutserts or something im missing between the sports bar and tub. What can i do here? The second, is the hard lid corner pieces dont cover the front edge of the tub and appear to need trimming. Is this normal? -
Just curious if anyone else is having issues with the car alarm going off randomly after mins to hours when locking with the key fob? Could this be an issue with the immobiliser? -
Hi again, Joel. Apart from being told that you should replace the rotors, what is wrong with them? do you have brake shudder, or are the rotors too thin, i.e. beyond their wear limit? If there are no symptoms of rotor problems I would clean the old ones and reuse them. Maybe new brake pads. As the hubs have come off you have disturbed the bearings, so clean them thoroughly, pack them with a bearing grease and reinstall them. Herb -
Prob a dumb question but can you raise the height of standard GXL 2023 suspension just temp and only slightly to stop front tyre rub on inside of arb summit guard until I can get a proper lift in a few weeks thanks Jamie -
Hi Joel, From the repair manual 1989 to 2004, here is an extract about the front rotors. Herb
-
-
Topics
-
-
