Jump to content


Brisbane Meetup (Every Thursday 9pm)

Danthuyer
 Share

Recommended Posts

  • Replies 3.8k
  • Created
  • Last Reply

Top Posters In This Topic

Popular Days

Top Posters In This Topic

Popular Days

Posted Images


DJKOR Grand Master

DJKOR

Posted
Posted

Damn.... I kinda wish I bought a Supra.

Was good to meet a few new faces tonight and see some familiar faces again.

Andrew357 Grand Master

Andrew357

Posted
Posted

Was a good turnout tonight.

Got beaten by a Golf TDI on the way home as well. Didn't realise he wanted to go me until it was too late and he beat me by 1/2 to 3/4 of a car length. Hrmmm... 5.5psi pulley + E-manage to compensate for my aloofness.... spiteful.gif

Steven Grand Master

Steven

Posted
Posted

really enjoyed finally putting a face to the names tonight. Usually I work fridays hence coming along is not always possible but I will attempt to pop in to say hi as often as possible.

Evo7 Grand Master

Evo7

Posted
Posted

Good night tonight everyone,

i only got home at 11:30pm, i got stuck in roadworks traffic near the dome, 3 lanes of traffic into 1 = FAIL!

Good to see everyone again :D

i'll be out again,next time however I am not sure when... but of course, i shall always be here :P

it was good to see Daryl's new play thing and same with Andrew's :D cars look tidy as... now if only i could blend mine in... XD

Have a good one, i am off to bed,

Evo

1stKill Grand Master

1stKill

Posted
Posted

Sighhhh,i wish sometimes i lived in QLD (thursday nights mainly ;) ) be great to catch up with all these fine looking Aurions on a regular basis,not much down here for the big cat of the toyota fleet,need a Rolla to fit in down here. :P

p.s hope a few of you Aurion lads (with cars) turn up to Sydney for the annual. :)

Andrew357 Grand Master

Andrew357

Posted
Posted

Yes, sunny QLD is Aurion central. It's starting to get intimidating up here. blink.gif

Andrew357 Grand Master

Andrew357

Posted
Posted

I'm back. So I'll be out next week.

I therefore demand to see daryl and Andrew there too. Hahaha

Ahh yes, supercharger time + accommodation time.

I'll have my dyno sheet with me next week too. Going for a run tomorrow.

DJKOR Grand Master

DJKOR

Posted
Posted

Such disappointment. I will no longer be able to make it out tomorrow night. Some people couldn't organise things right, so I will be in the Hunter Valley again for the next couple of days.

Still go out Steven, Mick will have my grill for you.

Steven Grand Master

Steven

Posted
Posted

Such disappointment. I will no longer be able to make it out tomorrow night. Some people couldn't organise things right, so I will be in the Hunter Valley again for the next couple of days.

Still go out Steven, Mick will have my grill for you.

sorry to hear that mate, will have to tee up another time to have a look at your satnav too. Thanks again for the effort with the grill.

chicaboo Grand Master

chicaboo

Posted
Posted

Such disappointment. I will no longer be able to make it out tomorrow night. Some people couldn't organise things right, so I will be in the Hunter Valley again for the next couple of days.

Still go out Steven, Mick will have my grill for you.

On the bright side, there are some awesome driving roads down in the Hunter Valley. :whistling:

DJKOR Grand Master

DJKOR

Posted
Posted

On the bright side, there are some awesome driving roads down in the Hunter Valley. :whistling:

Not so awesome when you have to drive a ZRE Rolla (sorry guys).

nate11six Grand Master

nate11six

Posted
Posted

Hi guys. I'll drop by tomorrow night.

If anyone is keen to take some fancy photos of my car, it'd be great.

But no dramas if people aren't able to.

See you all there after class.

SecaBoy Grand Master

SecaBoy

Posted
Posted

Daryl: ***** POOR EFFORT!!! :lol:

i'll be there... its been ages!!

car will be dirty as sh!t though... rain + mud + massive puddles = very very dirty car... :(

Guest

Guest

Posted
Posted

I shal be there, as i has a package to deliver :) (plus what else would I do on a Thursday nite)

chicaboo Grand Master

chicaboo

Posted
Posted (edited)

Recently I considered resuming Thursday night meets [which I stopped going to because of nightly roadworks].

It took me 1.5 hours to get home from Indooroopilly on Tuesday night because of stupid 4>1 lane reduction... <_<

So I'm still sitting them out until the frigging roadworks are finished or not as disruptive anymore. :huh:

Gav.

EDIT: And Daryl, you poor thing. I hope it's not the hatch you got stuck with. :o

Edited by chicaboo
Guest
This topic is now closed to further replies.
 Share
Go to topic listing



  • Join The Club

    Join the Toyota Owners Club and be part of the Community. It's FREE!

  • Latest Postings

    1. 0

      2017 Diesel d4d toyata hiace limp mode

      Hi i have a 2017 d4d toyota hiace purchased from new I am currently experiencing issues with my van It seems to be blowing dark black smoke apon acceleration and is very laggy under foot also No fault code on the dash but i have a a fault code of p1608 Lack of power code come up on my mechanics scanner Both my mechanic and toyota have no idea what the issue is
      JPE Services pty ltd in Toyota Commercial
    2. 1

      Tyre Sale Specials

      Tried to search prices on mycar website & nothing would load Tyroola also has 15% off site wide. Some good prices depending what your looking for https://www.tyroola.com.au/
      L4WL3SS in Club Lounge
    3. 0

      overheated engine

      I drive a 2010 series 200 sahara V8 automatic. I recently towed a small caravan on a not that hotter day. The temperature gauge went to about half then dropped back to normal. The motor then went into limp mode and eventually stopped. On lifting the bonnet i noticed the top radiator tank had split all the way across. I have only two months ago had the complete cooling system checked with no defects. I called the RAA in South Aust and they tried to start it but just turned over but did not fire up. It was still pretty hot. I have been told the motor would be ruined by overheating. The car has been sitting at the repairers for 5 days now and as far as i know it has not been attempted to start. Before putting a new motor in it would it be worth putting a new radiator in it and see if it will fire up? Open to any suggestions at this stage.
      wayne m in Landcruiser Club
    4. 1

      1996 Trueno XZ - Is it worth modding?

      Depends on how common/rare they are in your part of the world. The XZ trim was the second-lowest so didn't come with most of the fun bits that the full-fruit BZG/V/R models did, so it's not anywhere near as desirable stock but sometimes you have to make do with what you can find, plus you shouldn't feel as guilty modding the heck out of it since most of it isn't special.
      Hiro in Classic Toyota
    5. 62

      VSC, Traction Control, Check Engine lights all on

      I attended Toyota Preston for Aurion ATX 2013 major service today. Cost $~$1300. On the way home I stopped to pick up dinner. Two fault lights: engine and VSC lights came on when I restarted the car. Car drove home just fine. I can only return the car tomorrow for them to sort out. Annoyed. Let’s see if they’re still on in the morning.
      57John in Aurion / TRD Aurion Club
    6. 1

      1996 Trueno XZ - Is it worth modding?

      Hi everyone, new member to the group and owner driver of a nifty little Toyota Sprinter Trueno XZ, now this was my cousins car, I bought it off him and after various drives, I have come to the decision that this needs alot of love. Now I am wondering if its worth putting my time and money into doing this certain make n model up or should I just buy a different car to do up? I am not very car-inclined so I really don't know a lot. Any opinions would be very helpful Thankful!
      Danimal in Classic Toyota
    7. 1

      Query about the correct rotors for 2006 ACV40 Camry.

      I did a Google search. RDA 8112 suits your vehicle: TOYOTA CAMRY ACV40R 2.4L 2AZ-FE DOHC 16v MPFI 4cyl 117kW 5sp Auto 4dr Sedan FWD [06/06 – 09/11] TOYOTA CAMRY ACV40R 2.4L 2AZ-FE DOHC 16v MPFI 4cyl 117kW 5sp Man 4dr Sedan FWD [06/06 – 09/11] RDA 8112 Specifications: Specifications: Centre Hole Diameter: 62mm Flange Diameter: 62mm Minimum Thickness: 25mm Type: Vented Height: 49.2mm Diameter: 296mm Item Type: Disc Brake Rotor Material Type: Cast Iron Thickness: 28mm Pack Qty: Pair Stud Holes: 5 Position: Front RDA7686 RDA Brake Rotor 296mm x 26 Min (151mm Outer Hat Dia) Type DISC BRAKE ROTOR Brand RDA BRAKES Unit of Measure EACH Description RDA Brake Rotor 296mm x 26 Min (151mm Outer Hat Dia) Warranty 12 Months 20000kms Centre Hole Diameter 62mm Minimum Thickness 26mm Type Vented Note 151mm Outer Hat Diameter | (Use RDA8112 for 155mm) Height 50mm Diameter 296mm Item Type Disc Brake Rotor Thickness 28mm Number of Stud Holes 5 Position Front Brake Disc Type Vented Brake Disc Thickness 28 Centering Diameter 62
      campbeam in Camry Club
    8. 1

      Tyre Sale Specials

      I have been waiting and hoping for this Black Friday sale special to appear for 2024. 50% off all Pirelli Tyres. Main qualifying sale condition is: "Offer Tyres must be booked on Friday 29 November 2024 and be fitted between Monday 6 January 2025 and Saturday 15 February 2025." https://www.mycar.com.au/blackfriday?gad_source=1&gclid=Cj0KCQiAuou6BhDhARIsAIfgrn6ZbAnmv-FBFyT5UjZ5s9kCnKFSoMQLrVk3KXff7IqWPqq56qzU7oMaAr-eEALw_wcB&gclsrc=aw.ds
      campbeam in Club Lounge
    9. 10

      Android auto

      OK. Does any of Toyota's advertising material mention Android Auto? If so then kick up a stink, with Toyota management, about misrepresentation and false advertising, reminding them of the hefty fines. Herb
      ozieagle in RAV4 Club
    10. 0

      E160 Corolla fielder suspension

      Does any one know if the trd sportivo suspension for the 2017 facelift corolla fielder fits the 2013 prefacelift version? Is the chassis the same? Thanks for the help.
      jay886 in Corolla / Corolla Sportivo Club
×
×
  • Create New...

Forums

News

Membership