Camry Club
Subforums
-
- 649
- posts
2,976 topics in this forum
-
- 0 replies
- 781 views
-
- 1 reply
- 844 views
-
- 1 reply
- 676 views
-
- 2 replies
- 1.1k views
-
- 2 replies
- 1k views
-
- 2 replies
- 1.1k views
-
- 2 replies
- 2.2k views
-
- 1 reply
- 797 views
-
- 2 replies
- 1.4k views
-
- 4 replies
- 2.1k views
-
-
- 3 replies
- 762 views
-
- 4 replies
- 2.2k views
-
- 3 replies
- 7.5k views
-
- 3 replies
- 1.5k views
-
- 7 replies
- 4.3k views
-
- 3 replies
- 1.1k views
-
- 5 replies
- 1.7k views
-
- 4 replies
- 1k views
-
- 7 replies
- 1.2k views
-
- 6 replies
- 1k views
-
- 1 reply
- 2.1k views
-
- 1 reply
- 706 views
-
- 1 reply
- 891 views
-
- 3 replies
- 1.1k views
-
- 2 replies
- 994 views
-
Posts
-
-
-
I know there is a heap of discussion out there on this topic but has anyone successfully added cruise when the wiring harness doesn't support it? I was a hoping to just buy the clock spring and cruise stalk and fit it, but mines a manual and there is no wiring to connect the clutch switch to. I've read about people running wiring to the ECU, but there weren't any clear guides for this that i could find. How do you actually tap into the ECU connector because the pictures I've seen look like it wouldn't be easy to add anything to it? I gave up after seeing there was no clutch switch cabling to wire up to so I don't even know if the necessary cabling is between the clock spring and the ECU. Has anyone done this mod on a car that isn't pre-wired for it? -
Just purchased a 2008 Corolla hatch. As shown in the photo, the rubber shroud attached to the handbrake sags down and leaves a big gap for things to potentially fall down in there. I can't figure out why its like that. Nothing seems to be broken - is there something missing from there?
-
-
-
Topics
-
-
