Kluger Club
1,560 topics in this forum
-
- 26 replies
- 6.2k views
-
- 2 replies
- 4.6k views
-
- 6 replies
- 2k views
-
- 15 replies
- 8k views
-
- 5 replies
- 10.5k views
-
- 5 replies
- 2.3k views
-
- 4 replies
- 2k views
-
- 51 replies
- 12.4k views
-
- 4 replies
- 1.6k views
-
- 9 replies
- 16.6k views
-
-
- 85 replies
- 17.3k views
-
- 8 replies
- 9.9k views
-
- 2 replies
- 1.6k views
-
- 8 replies
- 2.5k views
-
- 5 replies
- 1.8k views
-
- 7 replies
- 2.6k views
-
- 2 replies
- 1.7k views
-
- 13 replies
- 2.4k views
-
- 5 replies
- 5.4k views
-
- 10 replies
- 2.1k views
-
- 4 replies
- 2.2k views
-
- 3 replies
- 2.5k views
-
- 6 replies
- 2.8k views
-
- 5 replies
- 2k views
-
- 3 replies
- 1.5k views
-
Posts
-
-
-
I know there is a heap of discussion out there on this topic but has anyone successfully added cruise when the wiring harness doesn't support it? I was a hoping to just buy the clock spring and cruise stalk and fit it, but mines a manual and there is no wiring to connect the clutch switch to. I've read about people running wiring to the ECU, but there weren't any clear guides for this that i could find. How do you actually tap into the ECU connector because the pictures I've seen look like it wouldn't be easy to add anything to it? I gave up after seeing there was no clutch switch cabling to wire up to so I don't even know if the necessary cabling is between the clock spring and the ECU. Has anyone done this mod on a car that isn't pre-wired for it? -
Just purchased a 2008 Corolla hatch. As shown in the photo, the rubber shroud attached to the handbrake sags down and leaves a big gap for things to potentially fall down in there. I can't figure out why its like that. Nothing seems to be broken - is there something missing from there?
-
-
-
Topics
-
-
